APPROACH CONTROL

9 questions · tap an answer to check it

Learn this topic firstSeparationAir Law course →

About this topic

APPROACH CONTROL: 9 multiple-choice questions for the DGCA CPL and ATPL examinations. Every question shows the correct answer and an explanation. You can practise free for a few minutes; a subscription opens every question bank, previous paper and airline preparation set.

Sample questions from APPROACH CONTROL

  1. If an arriving aircraft is making a straight in approach a departing aircraft may take off in any direction
    • A) Until five minutes before the arriving aircraft is estimated to be over the instrument runway
    • B) Until ten minutes before the arriving aircraft is estimated to be over the instrument runway
    • C) Until two minutes before the arriving aircraft is estimated to be over the instrument runway
    Show answer

    A) Until five minutes before the arriving aircraft is estimated to be over the instrument runway
    • Straight-in Approach. If an aircraft is making a straight-in approach, a departing aircraft may take off in any direction until 5 minutes before the arriving aircraft is estimated to be over the instrument runway OR in a direction which is different by at least 45 degrees from the reciprocal of the direction of approach of the arriving aircraft until 3 minutes before the arriving aircraft is estimated to be over th

  2. For controlled traffic that shall be separated in the vicinity of an airport, separation minima may be reduced:
    • A) At the discretion of the air traffic controller
    • B) When the commander in the following aircraft has the preceding aircraft in sight and is able to maintain own separation
    • C) If the commander of the involved aircraft so requests
    Show answer

    B) When the commander in the following aircraft has the preceding aircraft in sight and is able to maintain own separation
    In the vicinity of aerodromes, the separation minima may be reduced if: a) adequate separation can be provided by the aerodrome controller when each aircraft is continuously visible to this controller; or b) each aircraft is continuously visible to flight crews of the other aircraft concerned and the pilots thereof report that they can maintain their own separation; or c) in the case of one aircraft following another

  3. The EAT has to be transmitted to the pilot as soon as possible, in case the expected delay is:
    • A) 5 minutes or more
    • B) 15 minutes or more
    • C) 20 minutes
    Show answer

    A) 5 minutes or more
    A revised expected approach time shall be transmitted to the aircraft without delay whenever it differs from that previously transmitted by 5 minutes or more or such lessor period of time as has been established by the appropriate ATS authority or agreed between the ATS units concerned.

  4. A so called "Visual Approach" can be performed:
    • A) During VFR flight, there should be a visibility of 5 km or more
    • B) During IFR flight, if the cloudbase is 1000ft more than the appropriate DA or MDA for that procedure
    • C) During IFR flight. if there is permanent sight on the movement area and the underlying ground
    Show answer

    C) During IFR flight. if there is permanent sight on the movement area and the underlying ground
    Arriving IFR aircraft may be cleared for a Visual Approach if: The pilot can maintain visual reference to terrain. The reported ceiling is at or above the approved initial approach level. The pilot reports meteorological conditions allow a visual approach and landing during an instrument approach.

  5. "Time Approach Procedure" is used as necessary to expedite the approach of a number of arriving aircraft. This will be obtained requesting aircraft:
    • A) To maintain a specified speed during the approach procedure
    • B) To pass the specified point inbound at the previously notified tiem
    • C) To apply a step down descent between aircraft in the approach sequence
    Show answer

    B) To pass the specified point inbound at the previously notified tiem
    In Timed Approach, Aircraft are to be give a time at which to pass the specified point inbound (the purpose of which is to achieve the desired interval between successive landings on the runway while respecting the applicable separation minima at all times including runway occupancy period). The time determined is to be passed to the pilot to allow sufficient time for him/ her to arrange the flight to comply.