Air Law · Chapter 8
Instrument Departure Procedures
How a published departure keeps you clear of the ground when you cannot see it: gradients, turns and the charts that describe them.
© 2026 eatpl.in. For the personal study of eatpl.in students only. Do not copy or distribute.
e-books by eatpl.in · © 2026 · Do not copy or distribute
Chapter roadmap
What this chapter covers
01
The protection
PANS-OPS, protected areas, the climb gradient and obstacle clearance.
02
Kinds of departure
Straight, turning and omnidirectional; speeds and radar vectors.
03
Charts and RNAV
Reading a SID chart, MSA, and RNAV turns.
Chapter 8 · Instrument Departure Procedures
2
e-books by eatpl.in · © 2026 · Do not copy or distribute
Doc 8168
Where the procedures come from
- PANS-OPS, ICAO Doc 8168: Volume I flight procedures for pilots, Volume II construction rules for designers
- Departure procedures assume all engines are operating; engine-failure plans are the operator’s job
- Procedures show tracks: correct for the known wind, except when radar vectored, when you fly the heading given
- Each segment has a protected area: the primary area, half the width, with full obstacle clearance
- A secondary area each side, a quarter of the width, where clearance tapers to zero
Chapter 8 · Instrument Departure Procedures
3
e-books by eatpl.in · © 2026 · Do not copy or distribute
01
The protection
A climb you must achieve, and a margin that grows with distance.
e-books by eatpl.in · © 2026 · Do not copy or distribute
The procedure design gradient
Why you must climb at least 3.3%
Where it starts
At the end of the runway (the DER), 5 m (16 ft) up. Obstacle clearance there is zero.
3.3% = 2.5% + 0.8%
The OIS rises at 2.5%. Clearance grows by 0.8% of the distance flown. Together, the PDG of 3.3%.
When it is steeper
An obstacle through the OIS means a higher PDG, published with the height it applies to. Turn areas get at least 90 m (295 ft).
Chapter 8 · Instrument Departure Procedures
5
e-books by eatpl.in · © 2026 · Do not copy or distribute
02
Kinds of departure
Straight ahead, turning, or any direction.
e-books by eatpl.in · © 2026 · Do not copy or distribute
Straight and turning departures
Defined by the first track
Straight
If the first track is within 15° of the runway centre line. Guidance picked up within 20 km (10.8 NM) of the DER.
Turning
A turn of more than 15°. Fly straight until at least 120 m (394 ft) up; helicopters 90 m. Guidance within 10 km (5.4 NM) after the turn.
Where a turn starts
At a set altitude or height, at a fix, or overhead a facility.
Chapter 8 · Instrument Departure Procedures
7
e-books by eatpl.in · © 2026 · Do not copy or distribute
Omnidirectional
When there is no track guidance
- Used where no track guidance is provided: after the climb, turn in any direction
- Climb along the runway line to 120 m (394 ft) above the aerodrome before turning
- At least 90 m (295 ft) of clearance before turns over 15°; no turn within 600 m of the start of the runway
- Where obstacles intrude: a higher turn height, a steeper gradient, or closed sectors
- If none of that works: fly a SID, or make sure the weather lets you avoid obstacles visually
Chapter 8 · Instrument Departure Procedures
8
e-books by eatpl.in · © 2026 · Do not copy or distribute
Aircraft categories
Maximum speeds for departure procedures
| Category | Maximum speed | Typical aircraft |
|---|
| A | 225 km/h (120 kt) | light singles and twins |
| B | 305 km/h (165 kt) | turboprops, light jets |
| C | 490 km/h (265 kt) | most airliners |
| D | 540 km/h (290 kt) | large jets |
| E | 560 km/h (300 kt) | some military types |
Remember Faster means wider turns. Exceed the speed limit for the procedure and you may leave its protected area.
Chapter 8 · Instrument Departure Procedures
9
e-books by eatpl.in · © 2026 · Do not copy or distribute
Radar and SIDs
Vectors and where a departure ends
Accept vectors only if
You are above the height that keeps you clear of obstacles with an engine failed, or the route is not critical for obstacles.
Under vectors
Fly the heading given. Do not correct it for wind.
End of a SID
At the first fix, facility or waypoint of the en-route phase.
End of a gradient
When clearance is assured for the next phase: en-route, holding or approach.
No plates?
If diverted somewhere you have no chart for, ATC will read you the procedure.
Low-visibility ops
Take-off and landing with RVR below 800 m.
Chapter 8 · Instrument Departure Procedures
10
e-books by eatpl.in · © 2026 · Do not copy or distribute
03
Charts and RNAV
Reading the plate, and departures flown by waypoint.
e-books by eatpl.in · © 2026 · Do not copy or distribute
SID charts
What a departure chart shows
- Each SID has a designator; ATC clears you by that name to the first airway point
- The chart gives the route drawing, a written narrative in English, and height or gradient limits
- Restrictions read as “at” or “at or above” an altitude, often at a DME distance
- The minimum sector altitude (MSA) is the lowest safe altitude in each sector within 25 NM of a facility
- Charts follow Annex 4 (charts) and Annex 11 (air traffic services)
Chapter 8 · Instrument Departure Procedures
12
e-books by eatpl.in · © 2026 · Do not copy or distribute
RNAV
Departures flown by waypoint
Four kinds of turn
At a fly-by waypoint, at a fly-over waypoint, at an altitude, or a fixed-radius turn for RNP.
Approval
For an RNP procedure, the aircraft must be approved for that RNP, and you check before flight that you can meet it.
Ground aids
For DME-based RNAV, check the stations are working before flight.
Computer limits
The computer converts inputs into position, but it cannot catch a wrong input. Check the database.
Altitude turns
Some systems cannot code a turn at an altitude; then you fly it by hand.
FMS on a conventional SID
Allowed, if you monitor raw data on the basic display and stay within its tolerances.
Chapter 8 · Instrument Departure Procedures
13
e-books by eatpl.in · © 2026 · Do not copy or distribute
Summary
What to take into the exam
PANS-OPS
Doc 8168. Vol I pilots, Vol II designers. All engines operating. Correct for wind except on vectors.
Areas
Primary half the width, full MOC; secondary a quarter each side, tapering to zero.
Gradient
PDG 3.3% = OIS 2.5% + 0.8%. MOC zero at DER (5 m). 90 m in turn areas. Helicopters 5%.
Straight
Within 15°; guidance within 20 km (10.8 NM).
Turning
Over 15°; straight to 120 m (394 ft); guidance within 10 km (5.4 NM).
Omnidirectional
120 m before turns, 90 m clearance, nothing within 600 m of runway start. MSA: 25 NM.
Chapter 8 · Instrument Departure Procedures
14
e-books by eatpl.in · © 2026 · Do not copy or distribute