Air Law · Chapter 18
Markings, Signs and Lighting
Reading an aerodrome by eye: wind and signal aids, paint on runways and taxiways, signs, approach lights, PAPI, and runway and taxiway lights.
© 2026 eatpl.in. For the personal study of eatpl.in students only. Do not copy or distribute.
e-books by eatpl.in · © 2026 · Do not copy or distribute
Indicators
For pilots without a radio
- Windsock: fabric cone at least 3.6 m long, 0.9 m wide at the mouth, preferably white or orange; lit at night
- The main windsock sits in a white ring 15 m across, 1.2 m wide
- Landing T: white or orange; outlined or lit by white lights at night
- Signal lamp in the tower: red, green and white, and Morse at 4 words a minute or more
- Signal area: at least 9 m square with a white border; seen from 300 m. None means non-radio traffic is not accepted
Chapter 18 · Aerodromes: Markings, Signs and Lighting
2
e-books by eatpl.in · © 2026 · Do not copy or distribute
Runway markings are white
From threshold to aiming point
Threshold
Longitudinal “piano key” stripes, at least 30 m long, starting 6 m in; more stripes on wider runways. A transverse bar marks a displaced threshold.
Centre line
Stripe plus gap of 50–75 m; each stripe at least as long as the gap, or 30 m.
Aiming point
Two large bars. 400 m from the threshold where LDA is 2400 m or more (300 m for 1200–2400 m).
Touchdown zone
Pairs of bars every 150 m; 6 pairs on long code 4 runways. Required on precision runways.
Chapter 18 · Aerodromes: Markings, Signs and Lighting
3
e-books by eatpl.in · © 2026 · Do not copy or distribute
Designators
How a runway gets its number
- Magnetic direction of the runway as seen from the approach, divided by 10 and rounded: 274° → 27
- A single digit gets a leading zero: 06, not 6
- Parallel runways add L, C, R, from left to right as the pilot sees them
- Four parallels: one pair takes the next number, e.g. 26L 26R 27L 27R
- The opposite end differs by 18: 27 ↔ 09
Chapter 18 · Aerodromes: Markings, Signs and Lighting
4
e-books by eatpl.in · © 2026 · Do not copy or distribute
Taxiway markings
Yellow paint and holding points
- Taxiway and stand markings are yellow; the centre line leads from the runway to the stand
- Pattern A holding marking: two solid and two broken lines; always the one nearest the runway
- Approaching the runway you meet the solid lines first: stop there without a clearance
- Pattern B: a “ladder”, used for holding points further back, such as CAT II/III
- Intermediate holding: a single broken line where taxiways meet
- Apron safety lines keep vehicles clear of stands; in India they are red
Chapter 18 · Aerodromes: Markings, Signs and Lighting
5
e-books by eatpl.in · © 2026 · Do not copy or distribute
Aerodrome signs
Red means stop; yellow means information
Mandatory
White on red: runway, holding point, CAT I/II/III, road-holding, NO ENTRY. The only signs that use red.
Information
Black on yellow: direction, destination, runway exit, runway vacated.
Location
Yellow on black with a yellow border: where you are now.
Lighting
Lit when RVR is below 800 m, or at night on instrument runways.
Chapter 18 · Aerodromes: Markings, Signs and Lighting
6
e-books by eatpl.in · © 2026 · Do not copy or distribute
Approach lighting
White lights leading to the threshold
Simple
Centre line at least 420 m, with a crossbar at 300 m. For non-instrument and non-precision runways.
Precision CAT I
Centre line 900 m long, lights every 30 m; a 30 m crossbar at 300 m.
CAT II and III
As CAT I, plus red side rows over the inner 270 m and a second crossbar at 150 m.
Calvert
Used in the UK: distance-coded centre line with five crossbars.
Chapter 18 · Aerodromes: Markings, Signs and Lighting
7
e-books by eatpl.in · © 2026 · Do not copy or distribute
PAPI
The visual glide path
Layout
A wing bar of four units, normally on the left of the runway. APAPI has two.
Reading it
Each unit is red below its angle and white above. Two red, two white = on the slope.
MEHT
Minimum eye height over the threshold for the on-slope signal; check it against your aircraft.
Circling
A second wing bar on the right may be added to help with roll and circling.
Chapter 18 · Aerodromes: Markings, Signs and Lighting
8
e-books by eatpl.in · © 2026 · Do not copy or distribute
Runway lighting
Green in, white along, red at the end
Threshold
Green, across the runway; green wing bars at a displaced threshold. Edge lights before a displaced threshold show red to the approach.
Edge
White; yellow over the last 600 m or one-third, whichever is less.
Centre line
White; red and white from 900 m to 300 m before the end; all red over the last 300 m.
TDZ, end, stopway
Touchdown zone: white, first 900 m (CAT II/III). End: at least 6 red. Stopway: red.
Chapter 18 · Aerodromes: Markings, Signs and Lighting
9
e-books by eatpl.in · © 2026 · Do not copy or distribute
Taxiway lights
Blue edges, green centre, red stop
- Edge lights: blue, used where there is no centre line lighting
- Centre line: green; alternate green and yellow through the ILS sensitive area
- Stop bar: a row of red lights; do not cross while lit. Needed when RVR is below 350 m
- Runway guard lights: pairs of flashing yellow lights warning of an active runway
- Aerodrome beacon: white, or white and green flashes on land; identification beacon: aerodrome code in green Morse
Chapter 18 · Aerodromes: Markings, Signs and Lighting
10
e-books by eatpl.in · © 2026 · Do not copy or distribute
Summary
What to take into the exam
Colours
Runway paint white, taxiway paint yellow. Mandatory signs red; information yellow; location black.
Markings
Centre line 50–75 m. Aiming point 400 m. TDZ pairs every 150 m. Pattern A nearest.
Approach lights
Simple 420 m, CAT I 900 m, crossbar 300 m; CAT II/III red side rows 270 m.
PAPI
2 red + 2 white on slope; 4 units on the left; APAPI 2.
Runway lights
Threshold green; edge white, yellow last 600 m; centre line red last 300 m; end red.
Taxiway lights
Edge blue, centre green, stop bar red, guard lights flashing yellow.
Chapter 18 · Aerodromes: Markings, Signs and Lighting
11
e-books by eatpl.in · © 2026 · Do not copy or distribute