IFR Training · Chapter 7
ADF and NDB Tracking The simplest beacon and the hardest instrument to fly well: relative bearings, RBI and RMI, NDB errors, homing, tracking and interceptions.
Homing: nose on the needle NDB N © 2026 eatpl.in. For the personal study of eatpl.in students only. Do not copy or distribute.
e-books by eatpl.in · © 2026 · Do not copy or distribute
The N D B is the oldest and simplest radio aid still in use. On the ground it is just a transmitter. In the aircraft, the automatic direction finder has a needle that points at it. That sounds easy, and it is, until there is a crosswind, a thunderstorm, or a turn. The A D F gives you no warning flag and does no thinking for you, so more than any other aid it rewards a pilot who understands exactly what the needle is saying.
Roadmap
The needle points at the station. The rest is up to you The system A ground transmitter in the LF/MF band, and a needle that points to it. No failure flag.
RBI and RMI A fixed card gives relative bearing ; an RMI gives the QDM directly.
Errors Night effect, coastal refraction, thunderstorms, terrain, and dip in turns .
Flying it Track , do not home. Intercept and correct for drift, inbound and outbound.
Chapter 7 · ADF and NDB Tracking
2
e-books by eatpl.in · © 2026 · Do not copy or distribute
We start with the system and its biggest weakness. Then the two kinds of display, the fixed card and the R M I. Then the errors, which you must know for the exam and respect in the air. And then the flying: homing, tracking, intercepting, and passing over the station.
The system
A needle that points at a medium-frequency beacon The NDB transmits in all directions between 190 and 1750 kHz (LF/MF) The signal follows the earth's surface, so it is not limited to line of sight The aircraft ADF uses a loop and a sense aerial to find the direction of the signal The needle points to the station There is no failure flag. If the signal is lost the needle may simply stop or wanderSo identify the beacon, and keep monitoring the ident whenever you depend on it NDB N
Chapter 7 · ADF and NDB Tracking
3
e-books by eatpl.in · © 2026 · Do not copy or distribute
A non directional beacon transmits the same signal in all directions, in the low and medium frequency bands between one hundred and ninety and seventeen hundred and fifty kilohertz. At these frequencies the signal follows the surface of the earth, so unlike a V O R it is not limited to line of sight. In the aircraft, the automatic direction finder uses a loop aerial and a sense aerial to find where the signal is coming from, and a needle points to the station. Whichever way you turn, it keeps pointing there. But there is one great weakness. The A D F has no failure flag. If the signal is lost, the needle may simply stop where it is. So you must identify the beacon, and keep listening to the ident for as long as you depend on it.
Fixed card
The RBI shows relative bearing: you add the heading The card is fixed , with 0 at the top representing the aircraft's nose The needle reads relative bearing : degrees clockwise from the nose QDM = heading + relative bearing Heading 330°, relative bearing 050° → 380 − 360 = QDM 020° The tail of the needle gives the relative bearing from the station: add the heading for the QDR Every time the heading changes, the sum must be done again N 3 6 E 12 15 S 21 24 W 30 33 Heading 330° 0 3 6 9 12 15 18 21 24 27 30 33 RBI: relative bearing 050°
Chapter 7 · ADF and NDB Tracking
4
e-books by eatpl.in · © 2026 · Do not copy or distribute
The simplest display is the relative bearing indicator, or R B I. Its card is fixed, with zero at the top standing for the nose of the aircraft. The needle therefore shows relative bearing: how many degrees clockwise from the nose the station lies. To get a bearing you can use, add the heading. Magnetic heading plus relative bearing equals the Q D M. Here the heading is three three zero and the relative bearing is zero five zero. The sum is three hundred and eighty, so subtract three sixty, and the Q D M is zero two zero. The tail of the needle works the same way for the Q D R. The drawback is obvious: every time your heading changes, you have to do the sum again.
Moving card
The RMI does the sum for you The card is a compass card , slaved to the heading: your heading is at the top The head of the needle reads the QDM directly The tail of the needle reads the QDR Turn the aircraft: card and needle rotate together, and the reading does not change Many RMIs have two needles, switchable between ADF and VOR If the compass card fails, the needle still shows relative bearing against the top index N 3 6 E 12 15 S 21 24 W 30 33 Heading 330° · QDM 020° · QDR 200° N 3 6 E 12 15 S 21 24 W 30 33 After a turn to 060°: QDM still 020°
Chapter 7 · ADF and NDB Tracking
5
e-books by eatpl.in · © 2026 · Do not copy or distribute
The radio magnetic indicator, or R M I, does the sum for you. Its card is a compass card, driven by the aircraft compass system, so your heading is always at the top. The needle is superimposed on it. So the head of the needle points to the Q D M on the card, and the tail points to the Q D R. In the first picture the heading is three three zero and the head of the needle is on zero two zero. Now turn the aircraft on to zero six zero. The card and the needle rotate together, and the head still reads zero two zero. If the compass card ever fails, the instrument is not useless: the needle still shows the relative bearing against the index at the top.
Errors
Six things that bend an NDB bearing Night effect Sky waves returning from the ionosphere mix with the ground wave. Worst around dusk and dawn ; the needle wanders.
Coastal refraction The signal bends as it crosses a coastline at an angle. Use beacons near the coast or bearings at 90° to it.
Thunderstorms Static and lightning pull the needle towards the storm . Bearings become unreliable.
Terrain effect Mountains reflect and bend the signal, giving false bearings at low level.
Quadrantal error The airframe re-radiates the signal. It is calibrated out on installation.
Dip (bank) error In a turn the needle is in error by up to about 10° . Read it only with the wings level .
Promulgated accuracy is about ±5° within the published range, by day . Station interference is worse at night.
Chapter 7 · ADF and NDB Tracking
6
e-books by eatpl.in · © 2026 · Do not copy or distribute
Six things can bend an N D B bearing. Night effect: sky waves reflected from the ionosphere interfere with the ground wave, especially around dusk and dawn, and the needle wanders. Coastal refraction: the signal bends as it crosses a coastline at an angle. Thunderstorms: static and lightning pull the needle towards the storm. Terrain effect: mountains reflect the signal. Quadrantal error: the airframe itself re radiates the signal, which is calibrated out when the equipment is installed. And dip, or bank error: in a turn the needle can be wrong by about ten degrees, so read it only when the wings are level. The published accuracy is about plus or minus five degrees, within the promulgated range, and by day only.
Homing
Homing: nose on the needle, and a curved track Homing means keeping the needle on the nose and following itIn a crosswind the aircraft is blown downwind, the needle moves, and you turn to follow The result is a curved track that arrives from the downwind side, heading into wind It takes longer , and you do not know where you are over the ground It gives no protection from obstacles : procedures assume you are on the published track Homing is acceptable only as a last resort, or very close to the beacon Intended track 270° Homing: nose on the needle NDB N
Chapter 7 · ADF and NDB Tracking
7
e-books by eatpl.in · © 2026 · Do not copy or distribute
The simplest way to reach a beacon is to home on it: put the needle on the nose and keep it there. Watch what happens in a crosswind. The wind blows the aircraft downwind of its intended track. The needle moves off the nose, and the pilot turns to follow it. This goes on continuously, and the result is a curved track over the ground, which arrives at the beacon from the downwind side with the nose pointing almost into the wind. Homing takes longer, and you never know quite where you are. More seriously, instrument procedures only protect you from obstacles when you are on the published track. So homing is a last resort. The proper technique is tracking.
Tracking inbound
Tracking: the needle sits off the nose by the wind correction On the desired QDM with no drift , the needle is on the nose It moves off: turn towards the needle , by double the deviation, to get back on track On track again, turn back but keep a wind correction angle into wind Now the needle sits off the nose by the correction angle, on the downwind side Correction 10° right → relative bearing 350° . Correction 10° left → 010° On an RMI it is simpler: the head of the needle stays on the desired QDM Track 270° Heading 280° · QDM steady at 270° NDB N
Chapter 7 · ADF and NDB Tracking
8
e-books by eatpl.in · © 2026 · Do not copy or distribute
Tracking means flying a straight line over the ground to the beacon. With no drift, the needle would sit on the nose. When the wind moves you off track, the needle moves off the nose. Turn towards the needle by about double the deviation to regain the track. Once you are back on it, turn part of the way back, keeping a wind correction angle into the wind. Now comes the part that confuses people: when you are tracking correctly with a correction applied, the needle does not sit on the nose. It sits off the nose by the correction angle, on the downwind side. Here the aircraft heads two eight zero to track two seven zero, and the needle sits ten degrees to the left of the nose. The proof that you are tracking is that the Q D M stays constant.
Interceptions
Intercepting a QDM on the ADF Work out the intercept heading exactly as for a VOR: desired QDM → present QDM → 30° further Fly the heading and watch the needle: its head falls away from the nose You are on the desired QDM when the relative bearing equals the interception angle Intercepting from the left of the course at 60°: on track when the needle reads 060° relative On an RMI: on track when the head of the needle reaches the desired QDM Lead the turn by about 5° to 10° , and allow for dip once the bank goes on Desired QDM 280° Intercept heading 220° QDM 280° · needle on the nose NDB N
Chapter 7 · ADF and NDB Tracking
9
e-books by eatpl.in · © 2026 · Do not copy or distribute
Interceptions on the A D F use exactly the same thinking as on the V O R. Work out the intercept heading the same way: from the desired Q D M, through the present Q D M, and thirty degrees further. Then fly that heading and watch the needle. Its head will fall steadily away from the nose. You have reached the desired track when the relative bearing equals your interception angle. In this example the interception angle is sixty degrees, with the beacon to the right of the nose, so you are on track when the needle reads zero six zero relative. On an R M I it is easier: you are on track when the head of the needle reaches two eight zero on the card. Lead the turn by five to ten degrees, and remember the needle is unreliable once you bank.
Outbound
Station passage and tracking outbound on the tail Close to the beacon the needle becomes sensitive : stop chasing it and hold the heading Station passage : the needle swings through the wing tip and settles towards the tail Outbound, read the tail of the needle: it shows the QDR With a correction applied, the tail sits off the 180° mark by the correction angle Off track outbound: turn towards the track, so the tail of the needle moves towards the desired QDR : "pull the tail" An error grows with distance outbound, so correct it early QDR 270° Inbound Outbound on QDR 270° NDB N
Chapter 7 · ADF and NDB Tracking
10
e-books by eatpl.in · © 2026 · Do not copy or distribute
As you close on the beacon the needle becomes more and more sensitive. Stop chasing it and hold the heading that has been working. Station passage is when the needle swings round through the wing tip and settles towards the tail. Start your stopwatch if the procedure needs it. Outbound, you read the tail of the needle, which shows the Q D R. With a wind correction applied, the tail sits off the one eighty mark by the correction angle. If you are off track outbound, turn towards the track, and think of it as pulling the tail of the needle towards the Q D R you want. Because you are flying away from the beacon, any tracking error grows with distance, so correct it early.
Summary
What to carry into the cockpit and the exam No flag Identify the NDB and keep monitoring it. The needle gives no warning of failure.
RBI Relative bearing. QDM = heading + relative bearing.
RMI Head = QDM, tail = QDR, whatever the heading.
Errors Night effect, coastal refraction, thunderstorms, terrain, quadrantal, dip.
Track, do not home Homing curves downwind. Tracking keeps a constant QDM with the needle off the nose.
Interception On track when relative bearing = interception angle. Outbound, use the tail.
Chapter 7 · ADF and NDB Tracking
11
e-books by eatpl.in · © 2026 · Do not copy or distribute
In summary. The A D F has no failure flag, so identify the beacon and keep monitoring it. The R B I shows relative bearing, and heading plus relative bearing gives the Q D M. On an R M I the head of the needle is the Q D M and the tail is the Q D R. Know the six errors, and read the needle only with the wings level. Track, do not home. When tracking with a wind correction, the needle sits off the nose by that correction. And during an interception, you are on track when the relative bearing equals the interception angle.