IFR Training · Chapter 2
Basic Instrument Manoeuvres Straight and level, speed changes, climbs, descents, level-offs and rate one turns, flown by numbers on the instruments.
© 2026 eatpl.in. For the personal study of eatpl.in students only. Do not copy or distribute.
e-books by eatpl.in · © 2026 · Do not copy or distribute
In this lesson we put the control and performance method to work. Every instrument flight is built from just four manoeuvres: straight and level, climbs, descents and turns. If you can fly each of them accurately, and move smoothly from one to the next, you can fly any procedure on any chart. We will go through them one at a time, with the numbers and the rules of thumb that make them easy.
Roadmap
Four manoeuvres build every procedure Straight and level Hold altitude and heading; correct small errors with small, measured changes.
Climbs and descents Power, attitude, trim going up or down; attitude, power, trim levelling off.
Turns Rate one, timed at 3° per second , with a roll-out lead of half the bank angle.
Combinations Climbing and descending turns and speed changes, as every approach demands.
Chapter 2 · Basic Instrument Manoeuvres
2
e-books by eatpl.in · © 2026 · Do not copy or distribute
There are four parts. Straight and level flight, with the corrections that keep you on altitude and heading. Climbs and descents, and how to level off at exactly the right altitude. Turns at rate one. And then combinations of these, because real procedures rarely ask for one thing at a time.
Straight and level
Hold the altitude with pitch, the heading with wings level Set the level attitude and cruise power, trim, then cross-check Altitude off by less than 100 ft : correct with half a bar of pitch Off by more than 100 ft : use a full bar , and add or reduce power if needed Aim for a correction rate of about twice the error : 100 ft off → 200 ft/min Lead the return to level by about 10% of the vertical speed An altitude error usually starts as a pitch error: fix the attitude first N
Chapter 2 · Basic Instrument Manoeuvres
3
e-books by eatpl.in · © 2026 · Do not copy or distribute
Straight and level sounds easy, but it is where accuracy is won or lost. Set the level attitude and cruise power, trim, and start the cross check. If the altitude is off by less than one hundred feet, a pitch change of half a bar width is enough. For more than one hundred feet, use a full bar, and help with power if you need to. A good target is a rate of correction of about twice the error: if you are one hundred feet low, climb back at two hundred feet per minute. As you near the altitude, lead the level off by about ten percent of the vertical speed. And remember, an altitude error almost always begins as a small pitch error, so fix the attitude first.
Heading
Correct the heading with a bank equal to the error Heading drifts only if the wings are not level or the ball is not centred For a small error, use a bank angle equal to the number of degrees to turn 5° off → 5° of bank. 10° off → 10° of bank Never more than rate one Check the turn coordinator for wings level and the ball for balance Re-set the heading indicator against the compass about every 15 minutes in steady flight N 3 6 E 12 15 S 21 24 W 30 33 6° left of heading 090° 20 10 10 20 Correct with 6° of bank L R 2 MIN TURN Well inside rate one N 3 6 E 12 15 S 21 24 W 30 33 Wings level on 090°
Chapter 2 · Basic Instrument Manoeuvres
4
e-books by eatpl.in · © 2026 · Do not copy or distribute
Heading only drifts when the wings are not level or the aircraft is out of balance. To correct a small error, use a bank angle equal to the number of degrees you need to turn. If you are five degrees off, use five degrees of bank. If you are ten degrees off, use ten. Never use more than rate one. Then confirm wings level on the turn coordinator and check that the ball is centred. One more habit: the heading indicator drifts slowly, so in steady, unaccelerated flight, check it against the magnetic compass about every fifteen minutes and reset it if necessary.
Speed changes
Changing speed in level flight To slow down : reduce power below the target setting; raise the nose gradually to hold altitudeAs the speed nears the target, set the power for the new speed and trim To speed up : add power above the target setting; lower the nose graduallyThe altimeter is primary for pitch throughout; the airspeed tells you when to re-set the power Extending flap or gear changes the trim and the attitude: know what to expect in your type Lead the power change by about 5 kt N
Chapter 2 · Basic Instrument Manoeuvres
5
e-books by eatpl.in · © 2026 · Do not copy or distribute
Approaches need speed changes in level flight, so practise them. To slow down, reduce the power to a little below the setting for the new speed, and as the speed falls raise the nose gradually to hold altitude. Just before the target speed, set the power for that speed, and trim. To speed up, do the opposite: add power beyond the target setting, lower the nose gradually as the speed builds, then set the power and trim. Throughout, the altimeter is your primary pitch instrument, and the airspeed indicator tells you when to reset the power. Flap and landing gear also change the trim and the attitude, so know what to expect in your aircraft.
Climbs
Entering a climb: power, attitude, trim Power : set climb powerAttitude : raise the nose to the climb attitude on the attitude indicatorTrim : once the climb speed has settledConstant-speed climb: the airspeed indicator is primary for pitch Constant-rate climb: the VSI is primary for pitch , airspeed for power More power needs right rudder: keep the ball centred and the heading constant Level Constant-speed climb Level off N
Chapter 2 · Basic Instrument Manoeuvres
6
e-books by eatpl.in · © 2026 · Do not copy or distribute
To enter a climb, remember the letters P A T: power, attitude, trim. Set climb power. Raise the nose to the climb attitude on the attitude indicator. Then, when the speed has settled, trim. In a constant speed climb the airspeed indicator becomes the primary instrument for pitch: if the speed is high, raise the nose slightly, and if it is low, lower it. If you are asked for a constant rate climb instead, the vertical speed indicator is primary for pitch and the airspeed is controlled with power. Do not forget the rudder. Climb power needs right rudder to keep the ball centred and the heading steady.
Levelling off
Level off: attitude, power, trim, with a 10% lead Begin to level off before the altitude: lead by 10% of the vertical speed Climbing at 500 ft/min → start 50 ft below From a climb: Attitude to level, let the speed build, then Power to cruise, then Trim From a descent at cruise speed: lead by 10%, add power as you level From a descent to level at a higher speed than the descent speed: lead by about 100 to 150 ft and add power early Call out "1,000 to go" and "100 to go" to yourself: it prevents altitude busts 0 1 2 3 4 5 6 7 8 9 ALT Passing 4,950 ft for 5,000 4,950 20 15 10 5 0 5 10 15 20 VERT SPEED ×100 FPM Climbing at 500 ft/min 20 10 10 20 Lower the nose to level 40 60 80 100 120 140 160 180 200 AIRSPEED KNOTS Then power, then trim
Chapter 2 · Basic Instrument Manoeuvres
7
e-books by eatpl.in · © 2026 · Do not copy or distribute
Levelling off uses the same three letters in a different order: A P T. Attitude, power, trim. If you wait until you reach the altitude, you will go through it, so lead the level off by ten percent of your vertical speed. Climbing at five hundred feet per minute, start to lower the nose fifty feet below your altitude. Let the speed build towards cruise, then reduce to cruise power, then trim. From a descent, lead by ten percent as well and bring in the power as you level. If you want to level off at a speed higher than your descent speed, lead by rather more, about one hundred to one hundred and fifty feet, and add the power early.
Descents
Descents: constant speed or constant rate Power : reduce to the descent settingAttitude : lower the nose to hold the chosen speed (or the chosen rate)Trim Constant-rate descents are the norm on approaches: pitch for rate, power for speed On a 3° path, rate of descent ≈ ground speed × 5 (90 kt → about 450 ft/min) About 300 ft per nautical mile on a 3° path Level Descent at 450 ft/min Level off N
Chapter 2 · Basic Instrument Manoeuvres
8
e-books by eatpl.in · © 2026 · Do not copy or distribute
Descents are entered with power, attitude, trim once again. Reduce the power to the descent setting, lower the nose, and trim. You can descend at a constant speed, where the airspeed is held with pitch, or at a constant rate. On an approach the constant rate descent is normal: you hold the rate with pitch, and the speed with power. Two rules of thumb are worth learning now, because you will use them on every approach. On a three degree path, the rate of descent in feet per minute is about five times your ground speed in knots, so ninety knots needs about four hundred and fifty feet per minute. And a three degree path loses about three hundred feet in every nautical mile.
Turns
Rate one turns: three degrees every second Roll in smoothly to the rate one bank: about TAS ÷ 10 + 7 Add a little back pressure to hold altitude; the altimeter is primary for pitch The turn coordinator on its mark confirms rate one; keep the ball centred 30° takes 10 s, 90° takes 30 s, 180° takes 1 min, 360° takes 2 min Roll out with a lead of half the bank angle : 18° of bank → start 9° before the heading Relax the back pressure as the wings come level Heading 360° Rate one: 3°/s Heading 180° N
Chapter 2 · Basic Instrument Manoeuvres
9
e-books by eatpl.in · © 2026 · Do not copy or distribute
Now the turn. Roll in smoothly to the bank angle for rate one, which is about a tenth of the true airspeed plus seven degrees. As the bank goes on, add a little back pressure to hold altitude, with the altimeter as your primary pitch instrument. The turn coordinator on its mark confirms rate one, and the ball must stay centred. Rate one is three degrees per second, so thirty degrees takes ten seconds, ninety degrees takes thirty seconds, and one hundred and eighty degrees takes one minute. To roll out on a heading, lead by half the bank angle. With eighteen degrees of bank, start rolling out nine degrees before the heading, and relax the back pressure as the wings come level.
Combinations
Climbing and descending turns Establish one thing at a time : start the climb or descent, then roll into the turn (or the reverse) In a climbing turn, limit the bank: steep bank reduces the rate of climb In a descending turn the rate of descent tends to increase : watch the VSI Widen the scan: attitude indicator, then altimeter, heading and airspeed in turn Plan to reach the heading and the altitude separately , each with its own lead If the workload builds, level the wings first , then sort out the pitch Level Descending turn Level off N
Chapter 2 · Basic Instrument Manoeuvres
10
e-books by eatpl.in · © 2026 · Do not copy or distribute
Procedures often ask you to turn while climbing or descending. The secret is to establish one thing at a time. Start the descent, get it stable, and then roll into the turn; or start the turn and then begin the descent. In a climbing turn, keep the bank moderate, because a steep bank eats into the rate of climb. In a descending turn the rate of descent tends to increase, so watch the vertical speed. Widen your scan to take in the altimeter, heading and airspeed in turn, and plan the roll out and the level off separately, each with its own lead. If it all becomes too busy, level the wings first, and then sort out the pitch.
Fly by numbers
Build a table like this for your own aircraft Phase Power Attitude Performance Cruise Cruise setting Level Cruise speed, level Climb Climb power Climb attitude, a few degrees nose up Best-rate or cruise-climb speed Cruise descent Reduced by a fixed amount Slightly nose down Cruise speed, about 500 ft/min Approach level Approach setting Slightly nose up Approach speed, level Approach descent (3°) A little less than approach level About 2° to 3° lower Approach speed, ground speed × 5 ft/min Missed approach Full power Climb attitude Positive rate, then clean up
Fill in the real power settings, attitudes and speeds from your aircraft's flight manual and your own flying. Six lines cover almost every instrument flight.
Chapter 2 · Basic Instrument Manoeuvres
11
e-books by eatpl.in · © 2026 · Do not copy or distribute
Finally, a habit that separates relaxed instrument pilots from busy ones: fly by numbers. For your own aircraft, write down the power setting and the pitch attitude that give you each of six conditions: cruise, climb, cruise descent, level at approach speed, the approach descent, and the missed approach. Take the figures from the flight manual and refine them in the air. Then, whenever you need a new phase of flight, you simply set the known power and the known attitude, trim, and the performance follows with only small corrections. That frees your attention for navigation, the radio and the chart, which is where it is needed.
Summary
What to carry into the cockpit and the exam Level Half a bar under 100 ft, a full bar over. Correct at twice the error; lead by 10%.
Heading Bank equal to the degrees of error, never more than rate one.
Climb and descend Power, attitude, trim to enter. Attitude, power, trim to level, leading by 10% of the rate.
Three degree path Rate ≈ ground speed × 5. Height ≈ 300 ft per NM.
Rate one 3°/s. Bank ≈ TAS/10 + 7. Roll-out lead = half the bank angle.
By numbers Known power + known attitude = known performance.
Chapter 2 · Basic Instrument Manoeuvres
12
e-books by eatpl.in · © 2026 · Do not copy or distribute
Let us pull it together. In level flight, use half a bar for errors under one hundred feet and a full bar for more, and correct at twice the error. Fix heading errors with a bank equal to the error. Enter climbs and descents with power, attitude, trim, and level off with attitude, power, trim, leading by ten percent of the rate. On a three degree path, the rate of descent is five times the ground speed. Rate one is three degrees per second, and you roll out with a lead of half the bank angle. And fly by numbers: known power and known attitude give known performance.