Aircraft Instruments · Chapter 29
The autothrottle and thrust management: inputs and feedback, engagement, take-off, N1, speed, retard and go-around modes, warnings, flexible take-off, thrust computation and FADEC.
Exclusive study material prepared by eatpl.in
Arrow keys, the buttons or swipe to move between pages. The Lab is below the e-book.
Instruments · Chapter 29
The thrust management system: modes, limits and protections from the take-off roll to the landing, plus FADEC and Airbus-style auto-thrust.
Introduction
The system
The system
Typical twin jet
Typical twin jet
Typical twin jet
A/T modes
A/T modes
A/T modes
A/T modes
| Mode | When | What the levers do |
|---|---|---|
| ARM | Switch at ARM, no mode engaged; or a mode deselected | Free for manual positioning |
| THR HLD | Take-off from 84 kt until 400 ft RA + 18 s | A/T cannot move them; pilot can |
| RETARD (descent) | LVL CHG and VNAV descents | Back towards idle; ARM at the aft stop (or if held) |
| RETARD (landing) | 2½ s after FLARE, or 27 ft RA, whichever first | To idle for touchdown |
| RETARD (non-precision) | Flaps ≥ 15, not in ALT ACQ/HOLD: at 27 ft RA | To idle |
| Disconnect | About 2 s after touchdown | A/T disengages automatically |
A/T modes
Warnings
Indications
Reduced thrust
Thrust computation
FADEC
| Function | Includes |
|---|---|
| Gas generator control | Fuel flow, accel/decel schedules, variable bleed valves and stator vanes, turbine clearance, idle setting |
| Engine limit protection | N1 and N2 overspeed |
| Power management | Thrust rating, thrust parameter limits, auto-thrust demand, manual lever demand |
| Automatic start | Controls start valve, fuel and ignition; monitors N1, N2, FF, EGT |
| Manual start | Passive monitoring of the same parameters |
| Advantages | Less crew workload, limit protection, longer engine life, fuel and maintenance savings |
It allows for bleed air for air conditioning and anti-ice, temperature, static pressure and accessory loads.
FADEC
FADEC
FADEC
| Mode | When | Thrust |
|---|---|---|
| Manual | A/THR not armed, or armed but not active (lever outside A/THR range, no alpha floor) | Each lever sets an N1; in a detent N1 = the rating limit |
| FLX/MCT on the ground | Flex temperature > current TAT entered on the MCDU | FLX take-off thrust; otherwise MCT |
| FLX → MCT after take-off | Lever to TOGA or CL, then back to MCT | MCT; FLX no longer possible |
| Maximum take-off | Lever fully forward | Always available |
| Automatic (A/THR active) | Lever in the A/THR range | Computed by the FMGC, limited to the lever position (except alpha floor) |
FADEC inputs: air data, target N1, lever angle, N1/N2, EGT, fuel flow. Outputs: data to the FMGS, thrust parameters, fuel metering, N1 command to ECAM.
Exam traps
Summary