Aircraft Instruments · Chapter 2
Where the air data instruments get their pressures: static, dynamic and total pressure, pitot tubes, static heads and vents, position and manoeuvre-induced errors, blockages, the emergency static source and pre-flight checks.
Exclusive study material prepared by eatpl.in
Arrow keys, the buttons or swipe to move between pages. The Lab is below the e-book.
Instruments · Chapter 2
Pitot and static pressure, the heads and vents that sense them, their errors, blockages and the alternate static source.
Three pressures
Who gets what
Total pressure source
Static pressure source
Pressure head
Position (pressure) error
Position error in detail
Static vent
Two vents, one line
High-speed aircraft
Manoeuvre-induced error
Manoeuvre-induced error
Some numbers
| Condition | q = ½ρV² | Note |
|---|---|---|
| 100 kt TAS at MSL (ρ = 1.225 kg/m³) | ≈ 1 620 Pa ≈ 16 hPa | Small next to 1013 hPa static |
| 200 kt TAS at MSL | ≈ 6 480 Pa ≈ 65 hPa | 2 × speed → 4 × q |
| 300 kt TAS at MSL | ≈ 14 600 Pa ≈ 146 hPa | 9 × the 100 kt value |
| 200 kt TAS at 20 000 ft ISA (σ ≈ 0.53) | ≈ 3 450 Pa ≈ 35 hPa | Same q as ≈ 146 kt at MSL |
| Aircraft parked, no wind | 0 | Pitot = static |
The ASI senses q, so at altitude it shows less than the TAS: here about 146 kt for 200 kt TAS.
Blockages
| Blocked | ASI | Altimeter | VSI |
|---|---|---|---|
| Pitot only (drain open) | Falls towards zero as pitot pressure leaks away | Normal | Normal |
| Pitot and drain (inlet iced) | Acts as an altimeter: over-reads in the climb, under-reads in the descent | Normal | Normal |
| Static only | Under-reads in the climb, over-reads in the descent | Freezes at the blockage altitude | Reads zero |
| Both pitot and static | Freezes | Freezes | Reads zero |
Static blocked in the descent: the ASI over-reads, so you may fly too slow and risk the stall.
Blockage in action
Getting static back
Emergency static source
| Alternate source | Pressure sensed | Result |
|---|---|---|
| On the outside of the hull | Close to static, but the spot is not optimum | Larger position error than the normal vents |
| Inside the cabin (unpressurised aircraft only) | Lower than ambient, due to aerodynamic suction | ASI and altimeter over-read; VSI shows a brief climb |
| Inside a pressurised cabin | Cabin pressure, far higher than outside | Never used as a static source |
| Broken VSI glass (light aircraft) | Cabin pressure enters the static line via the VSI case | ALT and ASI usable (cabin errors); VSI lost |
Whichever source is used, apply the alternate-static corrections from the operating data.
Static vent versus static head
Pre-flight checks
Exam traps
Summary