Meteorology · Chapter 5
Humidity
Water vapour in the air: how much there is, how close the air is to saturation, dew point, wet bulb and why supercooled drops matter.
© 2026 eatpl.in. For the personal study of eatpl.in students only. Do not copy or distribute.
e-books by eatpl.in · © 2026 · Do not copy or distribute
Water in the air
The water cycle and the three states
- Water evaporates from oceans, lakes, rivers and plants, rises, condenses into cloud and falls as precipitation
- Three states: gas (water vapour), liquid (drizzle, rain, showers) and solid (snow, ice, hail)
- Changing state takes in or gives out latent heat, a huge source of energy for weather
- How much vapour the air can hold depends mainly on its temperature: warmer air holds more
- Almost all water vapour is in the troposphere
Chapter 5 · Humidity
2
e-books by eatpl.in · © 2026 · Do not copy or distribute
Saturation
Dry, moist and saturated air
Dry air
Air with no water vapour at all. Close to this only in the upper troposphere and the stratosphere.
Moist air
Ordinary air holding some vapour but less than the maximum: unsaturated. Meteorologists often call it “dry” at that temperature.
Saturated air
Like a full sponge: it holds the maximum vapour possible at its temperature. Any more, or any cooling, gives condensation.
Vapour pressure (e)
The partial pressure of the water vapour. If p is total pressure, the dry air contributes p − e.
Saturation vapour pressure
The vapour pressure when the air is saturated. It rises steeply with temperature.
The key link
Warm the air and its capacity grows, so it moves away from saturation; cool it and it moves towards saturation.
Chapter 5 · Humidity
3
e-books by eatpl.in · © 2026 · Do not copy or distribute
Capacity grows with temperature
Warm air can hold far more water vapour
Roughly, the capacity doubles for every 10 °C of warming. Values shown are approximate, at sea-level pressure.
Chapter 5 · Humidity
4
e-books by eatpl.in · © 2026 · Do not copy or distribute
Ways to measure water vapour
Absolute humidity, mixing ratio, RH
| Term | What it means | Units | When air is lifted (no water added or lost) |
|---|
| Absolute humidity | Mass of water vapour in a given volume of air | g/m³ | Changes, because the air expands |
| Humidity mixing ratio (HMR) | Mass of water vapour per mass of dry air | g/kg | Stays constant |
| Saturation mixing ratio | The maximum HMR at that temperature and pressure | g/kg | Falls as the air cools |
| Relative humidity (RH) | Actual vapour as a % of the maximum at the same temperature and pressure | % | Rises as the air cools |
| Vapour pressure | Partial pressure of the vapour | hPa | Falls with the total pressure |
RH = HMR × 100 / saturation HMR = VP × 100 / SVP. Measured with a psychrometer or hygrometer; recorded on a hygrograph.
Chapter 5 · Humidity
5
e-books by eatpl.in · © 2026 · Do not copy or distribute
Relative humidity
RH depends on vapour and on temperature
- RH (%) = actual ÷ maximum × 100
- Example: VP 21 hPa, SVP 42 hPa → RH = 50%
- Add vapour → RH rises. Warm the air → capacity rises, so RH falls
- So on a clear day RH is highest around dawn and lowest in the afternoon, though the vapour hardly changes
- At 100% RH the air is saturated; fog, cloud and rain need RH near 100%
Chapter 5 · Humidity
6
e-books by eatpl.in · © 2026 · Do not copy or distribute
Two important temperatures
Wet bulb and dew point
- Wet bulb (Tw): the lowest temperature air can reach by evaporating water into it until saturated. Desert coolers use this; drier air cools more
- Dew point (Td): the temperature to which air must be cooled at constant pressure to become saturated (over water)
- Dew point depends only on the water content; more vapour gives a higher dew point
- Warming or cooling the air changes RH, but not the dew point (until it condenses)
- Unsaturated: T > Tw > Td. Saturated (fog, rain): T = Tw = Td
Chapter 5 · Humidity
7
e-books by eatpl.in · © 2026 · Do not copy or distribute
Using the dew point
Spread, frost point and cloud base
- Dew point spread = T − Td. A small spread means air close to saturation; zero means saturated
- Frost point: the temperature for saturation with respect to ice; cooling below it gives hoar frost
- Cumulus base ≈ (T − Td) × 400 ft, using surface values in °C
- Example: T 30 °C, Td 22 °C → spread 8 → base ≈ 3200 ft
- A rising thermal cools faster than its dew point falls, so they meet at the base
Chapter 5 · Humidity
8
e-books by eatpl.in · © 2026 · Do not copy or distribute
Water and ice together
Saturation vapour pressure is lower over ice
- Below 0 °C, water molecules escape a liquid drop more easily than an ice surface
- So the SVP over water is greater than over ice at the same temperature
- Air saturated for the water drops is supersaturated for the ice crystals
- Drops evaporate and the vapour deposits on the crystals, which grow and fall: rain from clouds reaching above the 0 °C level
- Drops can stay liquid (supercooled) down to about −40 °C, and to about −45 °C in CB
Chapter 5 · Humidity
9
e-books by eatpl.in · © 2026 · Do not copy or distribute
Why it matters in flight
Humidity and the pilot
- High humidity lowers density: on a humid or rainy day the aircraft needs more runway
- A small spread on a clear evening warns of fog or low stratus by morning
- Spread and dew point give cloud base; a high dew point means plenty of fuel for thunderstorms
- Supercooled drops in cloud are the cause of airframe icing
- Saturated air: T = Td; METAR gives both, e.g. 28/24
Chapter 5 · Humidity
10
e-books by eatpl.in · © 2026 · Do not copy or distribute
Summary
What to take into the exam
Capacity
Depends on temperature: warmer air holds more vapour; roughly doubles every 10 °C.
Saturated air
Holds the maximum vapour. Vapour pressure e; SVP when saturated.
Absolute humidity
Vapour per volume, g/m³.
Mixing ratio
Vapour per mass of dry air, g/kg; constant when lifted.
Relative humidity
Actual ÷ maximum × 100. Warming lowers RH; highest near dawn.
Wet bulb, dew point
T > Tw > Td unsaturated; all equal when saturated. Td changes only with water content.
Cloud base
(T − Td) × 400 ft. Frost point: saturation over ice, hoar frost.
Water vs ice
SVP over water > over ice; crystals grow at the drops’ expense. Supercooled to −40 °C.
Chapter 5 · Humidity
11
e-books by eatpl.in · © 2026 · Do not copy or distribute