Performance · Chapter 8
Class A Landing Dispatch landing distance, wet and contaminated runways, the approach and landing climb, and the landing mass limits.
60 % jets · 70 % turboprops
Class A Landing © 2026 eatpl.in. For the personal study of eatpl.in students only. Do not copy or distribute.
e-books by eatpl.in · © 2026 · Do not copy or distribute
We finish the performance course where every flight ends: the landing. For airliners, the landing must be planned before departure with a generous margin, and the aeroplane must also be able to climb away if the landing is abandoned. Let's see how.
The margin 60 % or 70 % of LDA
Climb Approach and landing climb
Runway choice Still air and forecast wind
Chapter 8 · Class A Landing
2
e-books by eatpl.in · © 2026 · Do not copy or distribute
Here's the plan. The landing distance margins for jets and turboprops, the extra for wet and contaminated runways, the two climb requirements for an abandoned landing, how the landing runway is chosen at dispatch, and how all this limits the landing mass.
The margin
Stop within 60 %
50 ft at the threshold
jets: ≤ 60 % of LDA (× 1.67)
turboprops: ≤ 70 % of LDA (× 1.43)
Dispatch rule, dry runway: the aeroplane must stop well short of the end
Chapter 8 · Class A Landing
3
e-books by eatpl.in · © 2026 · Do not copy or distribute
How much runway does a landing need? Watch one landing, and then three lengths. First, the landing distance from the flight manual. It is measured from fifty feet above the threshold to a full stop, on a dry runway, flown by a test pilot in ideal conditions. Second, the landing distance available, LDA, which is the runway length you have. Third, the rule. At dispatch, a jet's manual distance must fit inside sixty per cent of the LDA, so forty per cent is kept as a safety margin. Put another way, multiply the manual distance by one point six seven, and the answer must not be more than the LDA. For a turboprop the figure is seventy per cent, a factor of one point four three.
The approach
A stable approach, and a bad one
50 ft at the threshold
jets: ≤ 60 % of LDA (× 1.67)
turboprops: ≤ 70 % of LDA (× 1.43)
Dispatch rule, dry runway: the aeroplane must stop well short of the end
Chapter 8 · Class A Landing
4
e-books by eatpl.in · © 2026 · Do not copy or distribute
The landing distance in the manual assumes a perfect arrival, so compare two landings. First, the stable approach. Gear down, landing flap, crossing the threshold at fifty feet and at the reference speed, VREF. VREF is at least one point two three times the stalling speed in the landing configuration. The aeroplane touches down early and stops with plenty of runway left. Second, the same aeroplane arriving too fast and too high. It floats, touches down much later, and uses up most of the margin. That is one reason the dispatch margin is so large.
Jet, chart landing distance 1 200 m
Dry: 1 200 ÷ 0.6 = 2 000 m required
Wet: 2 000 × 1.15 = 2 300 m required
Runway LDA 2 200 m
Dry: 2 000 ≤ 2 200 ✓
Wet: 2 300 > 2 200 ✗
Options: lower landing mass, another runway or aerodrome, or use a grooved / porous runway credit if approved.
Chapter 8 · Class A Landing
5
e-books by eatpl.in · © 2026 · Do not copy or distribute
A wet runway gives poorer braking, so the rules add another margin. First, the dry requirement. Take a manual distance of twelve hundred metres, divide by nought point six, and you need two thousand metres. Second, the wet requirement. Add fifteen per cent to the dry figure, which gives two thousand three hundred metres. Third, compare with the runway. If the landing distance available is twenty-two hundred metres, the dry landing fits but the wet one does not. So on a wet day we would need a lower landing mass, or a longer runway.
Contaminated
Contaminated runways
water film: the tyre can aquaplane
wet: 115 % of dry required
contaminated data × factor
Use the greater: here the contaminated figure.
Chapter 8 · Class A Landing
6
e-books by eatpl.in · © 2026 · Do not copy or distribute
A contaminated runway is covered with standing water, slush, snow or ice, and stopping takes much longer. First, the distance to use. Work out the wet figure, then the figure from the contaminated-runway data, and take the greater of the two. Second, the braking action. The reported runway condition tells you which data apply, and poorer braking means a longer stop. Third, the technique. Reverse thrust may be credited, and a firm touchdown helps the tyres break through the water film instead of aquaplaning.
Approach climb
One engine out, approach flap, gear up
2.1 % · 2.4 % · 2.7 % two · three · four engines
Landing climb
All engines, landing flap, gear down
3.2 % for all balked landing
Chapter 8 · Class A Landing
7
e-books by eatpl.in · © 2026 · Do not copy or distribute
The aeroplane must also be able to abandon the landing and climb away, and two separate checks prove it. First, the approach climb. One engine has failed, with approach flap and the gear up, and a twin must still climb at two point one per cent. Second, the landing climb. This is a balked landing with all engines working, but with landing flap and the gear down, and it needs three point two per cent. Either check can limit the landing mass on a hot day at a high aerodrome.
Runway choice
Which runway at dispatch? Still air : The landing must work on the most favourable runway in still air.Forecast wind : And on the runway most likely to be used given the forecast wind and the traffic, allowing for ground handling.If not : Dispatch is still possible if a destination alternate meets the rules.In flight : The 60 % margin is a planning rule; in flight, the actual conditions and in-flight assessment are used.
09 27
forecast wind
1. Most favourable runway, still air
2. Runway most likely in use (forecast wind)
Only 1 works → dispatch with a destination alternate
Chapter 8 · Class A Landing
8
e-books by eatpl.in · © 2026 · Do not copy or distribute
At dispatch, two runways are checked. First, the landing must be possible on the most favourable runway in still air. Second, it must be possible on the runway most likely to be assigned given the forecast wind and the traffic. If only the first works, the flight can still go if a suitable alternate is nominated. Remember the sixty per cent margin is a planning rule; in flight, the crew assess the actual conditions.
Limit What sets it Structural MLM Strength of gear and structure Field length Required landing distance within LDA Approach climb 2.1 % one engine out (twin) Landing climb 3.2 % all engines Brake energy / tyres Hot, high, heavy landings Back to take-off Planned take-off mass ≤ landing limit + trip fuel
Chapter 8 · Class A Landing
9
e-books by eatpl.in · © 2026 · Do not copy or distribute
The landing mass is the lowest of several limits: the structural maximum, the field length, the approach and landing climbs, and brake energy. And this feeds back to the take-off: the take-off mass can't be more than the landing limit plus the fuel burned on the way.
Turboprops ≤ 70 % LDA (× 1.43)
Wet × 1.15 of dry required
Approach climb 2.1 % twin, one engine out
Landing climb 3.2 %, all engines
Dispatch Still air and forecast wind runways
Chapter 8 · Class A Landing
10
e-books by eatpl.in · © 2026 · Do not copy or distribute
To sum up. Jets must land within sixty per cent of the landing distance available, turboprops within seventy. Add fifteen per cent for a wet runway. The approach climb needs two point one per cent on one engine for a twin, and the landing climb three point two per cent. And at dispatch, check both the still-air runway and the one the forecast wind will give you. That completes the performance course.