Performance · Chapter 4
Class B: Single-Engine Aeroplanes Take-off factors, climb, en route and landing rules for light single-engine aeroplanes, with a worked example.
×1.25 · ×1.15 · ×1.3 50 ft
Single-Engine Class B © 2026 eatpl.in. For the personal study of eatpl.in students only. Do not copy or distribute.
e-books by eatpl.in · © 2026 · Do not copy or distribute
Class B covers the small propeller aeroplanes most pilots learn on. The rules are simpler than for airliners, but they add safety margins on top of the manufacturer's figures. In this lesson we'll work through the take-off, en route and landing requirements for a single-engine aeroplane, and finish with a worked example.
Roadmap
Single-engine Class B Take-off Three distance checks
Corrections Surface, slope, wind
Climb VX, VY, no engine-out case
En route Somewhere to land
Example Putting it together
Chapter 4 · Class B: Single-Engine Aeroplanes
2
e-books by eatpl.in · © 2026 · Do not copy or distribute
Here's the plan for single-engine Class B. First the take-off distance checks, then the corrections for surface, slope and wind. Then the climb and en route, where the key question is what happens if the only engine stops. Then the landing rule, and finally a worked example.
Take-off
Three checks on the take-off distance
TORA stopway clearway
TOD × 1.25 ≤ TORA TOD × 1.15 ≤ TODA TOD × 1.3 ≤ ASDA
TOD = distance to 50 ft from the aeroplane chart. Without stopway or clearway, TOD × 1.25 ≤ TORA.
Chapter 4 · Class B: Single-Engine Aeroplanes
3
e-books by eatpl.in · © 2026 · Do not copy or distribute
The manufacturer's chart gives the take-off distance to a screen height of fifty feet. The rules then add margins. With no stopway or clearway, the chart distance times one point two five must fit within the take-off run available. If there is a clearway, the distance times one point one five must fit within the take-off distance available, and if there is a stopway, the distance times one point three must fit within the accelerate-stop distance available. Every check that applies must be met.
Corrections
Correcting the chart figure Short dry grass : × 1.2 Wet grass : × 1.3Each 1 % upslope : + 5 % Wind : 50 % headwind, 150 % tailwindThen apply the 1.25 / 1.15 / 1.3 check
Dry grass (short) × 1.2 Wet grass × 1.3 Wet paved × 1.0 Upslope, each 1 % + 5 % Headwind / tailwind 50 % / 150 %
Factors multiply together, and the regulatory factor (1.25, 1.15 or 1.3) goes on top.
Chapter 4 · Class B: Single-Engine Aeroplanes
4
e-books by eatpl.in · © 2026 · Do not copy or distribute
Before the checks, correct the chart distance for conditions it doesn't already include. On short dry grass multiply by one point two, on wet grass by one point three. For an upslope, add five per cent for each one per cent of slope. If the chart doesn't already do it, use half the headwind and one and a half times the tailwind. These factors multiply together, and then the regulatory factor goes on top.
Climb
Climbing with one engine No engine-failure climb case: there is no second engine Use VX for obstacles, VY for height Plan the take-off so a failure leaves a forced landing option
Dry grass (short) × 1.2 Wet grass × 1.3 Wet paved × 1.0 Upslope, each 1 % + 5 % Headwind / tailwind 50 % / 150 %
Factors multiply together, and the regulatory factor (1.25, 1.15 or 1.3) goes on top.
Chapter 4 · Class B: Single-Engine Aeroplanes
5
e-books by eatpl.in · © 2026 · Do not copy or distribute
A single-engine aeroplane has no engine-out climb to calculate: if the engine fails, it's coming down. So the climb is flown at VX if there are obstacles to clear, then VY to gain height quickly. The planning question is what you'd do after an engine failure, and the answer is a forced landing, so you want the departure path to give you somewhere to put it down.
En route
If the engine stops
field for a forced landing
engine stops
best glide speed
above cloud ✗
night ✗
open water ✗
A safe forced landing must always be possible, unless the authority approves otherwise.
Chapter 4 · Class B: Single-Engine Aeroplanes
6
e-books by eatpl.in · © 2026 · Do not copy or distribute
En route, a single-engine aeroplane must be able to make a safe forced landing if the engine fails. That means flights shouldn't be planned above cloud, at night, or over water beyond gliding range, unless the authority has approved it. In planning, assume the aeroplane glides from its cruise height at the best glide speed, and allow for the wind.
landing distance from 50 ft: no more than 70 % of LDA
30 % margin
Equivalent: chart distance × 1.43 ≤ LDA. Wet: × 1.15 more. Dry grass: × 1.15 more.
Cross the threshold at 50 ft, land and stop within 70 % of what's available
Chapter 4 · Class B: Single-Engine Aeroplanes
7
e-books by eatpl.in · © 2026 · Do not copy or distribute
For landing, the chart gives the distance from fifty feet above the threshold to a full stop. That distance must be no more than seventy per cent of the landing distance available. Put the other way, multiply the chart distance by about one point four three and it must fit the runway. On a wet runway add another fifteen per cent, and on dry grass another fifteen per cent as well.
Correct for surface and slope first Then apply the regulatory factor If it fails: lighter, more wind, or another runway
Example
Chart TOD to 50 ft: 520 m
Dry short grass: × 1.2 → 624 m
1 % upslope: × 1.05 → 655 m
Checks (no stopway, no clearway)
655 × 1.25 = 819 m ≤ TORA 850 m ✓
If the grass were wet
520 × 1.3 × 1.05 = 710 m
710 × 1.25 = 888 m > 850 m ✗
Reduce mass, wait for a headwind, or use a longer runway.
Chapter 4 · Class B: Single-Engine Aeroplanes
8
e-books by eatpl.in · © 2026 · Do not copy or distribute
Let's try one. The chart gives five hundred and twenty metres. On short dry grass that becomes six hundred and twenty-four, and a one per cent upslope takes it to about six hundred and fifty-five. Times one point two five is eight hundred and nineteen metres, which fits an eight hundred and fifty metre runway. But if the grass is wet, the same sum gives about eight hundred and eighty-eight metres, and it no longer fits.
Reference
Single-engine Class B factors Item Factor TOD within TORA (no SW/CW) × 1.25 TOD within TODA (with clearway) × 1.15 TOD within ASDA (with stopway) × 1.3 Dry grass take-off × 1.2 Wet grass take-off × 1.3 Upslope take-off + 5 % per 1 % Landing distance ≤ 70 % LDA (× 1.43) Wet runway landing × 1.15 Dry grass landing × 1.15
Chapter 4 · Class B: Single-Engine Aeroplanes
9
e-books by eatpl.in · © 2026 · Do not copy or distribute
Here are all the factors in one table. You'll use these again for the multi-engine Class B lesson, because the take-off and landing distance rules are the same.
Take-off 1.25 TORA, 1.15 TODA, 1.3 ASDA
En route Forced landing must be possible
Landing 70 % LDA; wet and grass +15 %
Chapter 4 · Class B: Single-Engine Aeroplanes
10
e-books by eatpl.in · © 2026 · Do not copy or distribute
To sum up. Class B uses a fifty foot screen. Check one point two five against the run, one point one five against the take-off distance, and one point three against the accelerate-stop distance. Correct first for grass and slope. En route, a forced landing must always be possible. And land within seventy per cent of the landing distance available, with fifteen per cent more for wet or grass.