Performance · Chapter 3
Climb, Cruise and Descent Excess thrust and excess power, VX and VY, ceilings, range and endurance, and the glide.
Climb Cruise Descent
Climb · Cruise · Descent © 2026 eatpl.in. For the personal study of eatpl.in students only. Do not copy or distribute.
e-books by eatpl.in · © 2026 · Do not copy or distribute
Once off the ground the questions change. How steeply can we climb, how fast can we gain height, at what speed should we cruise to go furthest, and how far can we glide? In this lesson we'll answer all of these from one simple idea: what's left over after drag has been paid for.
Roadmap
One idea: the surplus Gradient From excess thrust
Factors Mass, altitude, wind
Cruise Range and endurance
Chapter 3 · Climb, Cruise and Descent
2
e-books by eatpl.in · © 2026 · Do not copy or distribute
Climb, cruise and descent all come back to one idea: the surplus. Whatever thrust is left after paying for drag can be used to climb. We'll see how that gives the climb gradient and the rate of climb, the best speeds for each, what spoils them, and then how cruise and descent follow.
Forces
Why climbing needs a surplus
Thrust
Drag
Weight
W sin γ
Along the path: T = D + W sin γ
sin γ ≈ gradient = (T − D) ÷ W
Chapter 3 · Climb, Cruise and Descent
3
e-books by eatpl.in · © 2026 · Do not copy or distribute
In a steady climb the thrust has two jobs. It must pay for the drag, as in level flight, and it must also balance the part of the weight that now acts backwards along the climbing path. So the steeper the climb, the more thrust is needed beyond the drag.
Gradient
Gradient comes from excess thrust Gradient ≈ (T − D) ÷ W Bigger surplus or lighter aeroplane → steeper Best gradient at the speed with the biggest T − D : VX
Thrust
Drag
Weight
W sin γ
Along the path: T = D + W sin γ
sin γ ≈ gradient = (T − D) ÷ W
Chapter 3 · Climb, Cruise and Descent
4
e-books by eatpl.in · © 2026 · Do not copy or distribute
Rearranging the forces gives a very useful result. The climb gradient is roughly thrust minus drag, divided by weight. So to climb steeply you want the biggest surplus of thrust over drag, and a light aeroplane. The speed that gives the biggest surplus is VX, the best angle of climb speed.
VX and VY
Best angle, best rate VX : max excess thrust → steepest gradientVY : max excess power → most ft/minVX is always below VY Jet: VX ≈ VMD; Propeller: VX below VMD
mast
VX: steepest VY: fastest up
VX: best angle (gradient), obstacles VY: best rate (ft/min), time to altitude
Chapter 3 · Climb, Cruise and Descent
5
e-books by eatpl.in · © 2026 · Do not copy or distribute
Rate of climb is different. It depends on excess power, which is excess thrust times speed. Flying a little faster than VX loses a bit of thrust surplus but gains speed, so the rate goes up. The best rate comes at VY, which is always faster than VX. Use VX to clear an obstacle, VY to reach altitude quickly. For a jet VX is close to the minimum drag speed; for a propeller aeroplane, whose thrust falls as speed rises, it's lower.
The curves
Where VX comes from Jet thrust nearly flat with speed Drag curve has a minimum at VMD Biggest gap → VX Power curves give VY the same way
True airspeed → Thrust / drag → Thrust available (jet) Drag (thrust required) VX VY
Chapter 3 · Climb, Cruise and Descent
6
e-books by eatpl.in · © 2026 · Do not copy or distribute
Here's the picture behind it. A jet's thrust hardly changes with speed, while drag has a minimum at VMD. The biggest gap between them is the biggest thrust surplus, and that's VX. Do the same with power available and power required and the biggest gap gives VY.
Factors
What spoils the climb Mass up → gradient and rate down ; VX, VY up Altitude and temperature up → less thrust → both down Wind: rate unchanged, gradient over the ground changed
Climb is worse when…
Heavier more weight to lift, more induced drag Higher / hotter less thrust and power Flaps / gear out more drag Engine failed thrust halves, drag rises Headwind? rate unchanged, gradient over ground better
Chapter 3 · Climb, Cruise and Descent
7
e-books by eatpl.in · © 2026 · Do not copy or distribute
A heavier aeroplane climbs at a shallower gradient and a lower rate, and its best climb speeds are a little higher. Altitude and heat thin the air, so there's less thrust and both get worse. Flaps, gear and a failed engine all eat into the surplus. Wind is the odd one out: it doesn't change the rate of climb through the air, but a headwind steepens the gradient over the ground, and a tailwind flattens it.
Ceilings
How high can it go? Rate of climb shrinks as altitude rises Service ceiling : rate falls to 100 ft/min (piston)Absolute ceiling : rate falls to zeroHeavier → lower ceilings
0 500 1000 1500 2000 0 10 20 30 40 Rate of climb (ft/min) → Altitude (thousand ft) → Service ceiling (100 ft/min) Absolute ceiling (0)
Chapter 3 · Climb, Cruise and Descent
8
e-books by eatpl.in · © 2026 · Do not copy or distribute
As the aeroplane climbs, thrust falls and the rate of climb gets smaller. The service ceiling is where it's down to a hundred feet per minute; jets use a figure of about five hundred feet per minute. The absolute ceiling is where it reaches zero and the aeroplane can climb no further. A heavier aeroplane has lower ceilings.
Cruise
Range and endurance Endurance : least fuel per hourRange : least fuel per mileJet: endurance at VMD, range at about 1.32 VMD Propeller: endurance at VMP, range at VMD Headwind: fly a little faster for range
True airspeed → Drag → Drag VMD: endurance (jet) ≈1.32 VMD: range (jet)
Chapter 3 · Climb, Cruise and Descent
9
e-books by eatpl.in · © 2026 · Do not copy or distribute
In the cruise there are two different goals. Endurance means staying airborne as long as possible: least fuel per hour. Range means going as far as possible: least fuel per mile. A jet's fuel flow follows thrust, so it gets best endurance at the minimum drag speed and best range somewhat faster, at about one point three two times that speed. A propeller aeroplane gets best range at the minimum drag speed and best endurance a little slower. Into a headwind, fly a bit faster to cut the time the wind has to act.
still air headwind
Glide ratio = lift ÷ drag; best at VMD
Heavier: same ratio, higher speed, same still-air distance
Headwind: shorter over the ground; tailwind: further
Chapter 3 · Climb, Cruise and Descent
10
e-books by eatpl.in · © 2026 · Do not copy or distribute
With the engines idle, drag is paid for by descending. The glide ratio is lift divided by drag, so the flattest glide comes at the minimum drag speed. A heavier aeroplane glides at the same angle but faster, so it covers the same distance in still air, just sooner. Wind changes the picture over the ground: into a headwind you cover less ground, with a tailwind more.
Gradient (T − D) ÷ W, best at VX
Rate Excess power, best at VY > VX
Wind Changes gradient, not rate
Ceilings Service 100 ft/min, absolute 0
Jet cruise Endurance VMD, range ≈ 1.32 VMD
Glide Best at VMD; mass changes speed, not distance
Chapter 3 · Climb, Cruise and Descent
11
e-books by eatpl.in · © 2026 · Do not copy or distribute
To sum up. Gradient comes from excess thrust and is best at VX. Rate comes from excess power and is best at VY, which is faster. Wind changes the gradient over the ground but not the rate. The service ceiling is where the rate falls to a hundred feet per minute. A jet gets best endurance at VMD and best range a third faster. And the best glide is at VMD, whatever the mass.