About this topic
AEROFOIL: 30 multiple-choice questions for the DGCA CPL and ATPL examinations. Every question shows the correct answer and an explanation. You can practise free for a few minutes; a subscription opens every question bank, previous paper and airline preparation set.
Sample questions from AEROFOIL
- Two aircraft have the same wing shape and area if one has straight wings and the other swept wings how will the aspect ratios of the two aircraft compare?
- A) No change.
- B) Aspect ratio will increase as wings stveepback angle increases
- C) Aspect ratio will decrease as wing sweepback angle increases.
- D) Depends on the C of G position.
Show answer
C) Aspect ratio will decrease as wing sweepback angle increases.
Aspect Ratio (AR) = Wingspan² / Wing Area = Wingspan / Mean Chord For the same wing area, when wings are swept back, the projected span reduces, because the wingspan is measured perpendicular to the fuselage. Since the effective span decreases, aspect ratio decreases. - Which wing plan forms are most susceptible to tip stall?
- A) High aspect ratio, elliptical, Low taper ratio, straight.
- B) High aspect ratio, pointed, high taper ratio, swept.
- C) Low aspect ratio, elliptical, low taper ratio, straight.
- D) Low aspect ratio, pointed, low taper ratio, swept.
Show answer
B) High aspect ratio, pointed, high taper ratio, swept.
The tips of a high aspect ratio wing experience a higher angle of attack than those of a low aspect ratio wing with the same area, for any given aircraft attitude. Pointed wings and those with a high taper ratio exhibit similar effects (higher tip AoA). Airflow over swept back wings tends to migrate outwards, causing thickening of the boundary layer at the wing tips. This thicker boundary layer at the tips separates - Which of the following are true of low aspect ratio rectangular wings?
- A) They produce low induced drag and high profile drag.
- B) They produce low profile drag and high induced drag.
- C) They are difficult to construct and their roots stall before their tips.
- D) 'They are easy to construct and their tips stall before their roots.
Show answer
B) They produce low profile drag and high induced drag.
The rectangular section and short span make low aspect ratio wings easy to construct. Because of the short span and long chord, they produce strong tip vortices and hence high induced drag. The short span also reduces frontal area, thereby minimising profile drag. Because of the strong wingtip vortices, the tips of such wings experience low angles of attack and so stall first at the root. - In what direction is the airflow deflected as it passes over the tips of lift generating pointed wings.
- A) Downwards.
- B) Forwards.
- C) Upwards.
- D) Aft.
Show answer
C) Upwards.
On lift-generating pointed wings, the tips stall immediately, even at very small angles of attack. This early stall causes the vortices to form further inboard, which in turn leads to an upward deflection of airflow over the tips. Therefore, the airflow is deflected upwards as it passes over the tips of such wings. - Which of the following statements are true of elliptical wings? 1. Almost the entire wing reaches its stalling angle simultaneously. 2. It poses structural problems making design and construction difficult. , 3. The aircraft exhibits little or no pre-stall buffet. 4. Aileron effectiveness is reduced close to the stall.
- A) 1, 2,3.
- B) 1,2,4.
- C) 2,3,4.
- D) All of the above.
Show answer
D) All of the above.
Almost the entire wing reaches its stalling angle simultaneously – True due to uniform lift distribution. It poses structural problems making design and construction difficult – True due to the complex shape of elliptical wings. The aircraft exhibits little or no pre-stall buffet – True because the stall is abrupt and simultaneous. Aileron effectiveness is reduced close to the stall – True, as small deflections cause