About this topic
FLYING CONTROLS: 100 multiple-choice questions for the DGCA CPL and ATPL examinations. Every question shows the correct answer and an explanation. You can practise free for a few minutes; a subscription opens every question bank, previous paper and airline preparation set.
Sample questions from FLYING CONTROLS
- What control inputs are required to maintain airspeed a d altitude when turning in a jet aircraft?
- A) Increase thrust and angle of attack.
- B) Increase turn radius and decrease thrust.
- C) Increase pitching angle.
- D) Increase bank angle.
Show answer
A) Increase thrust and angle of attack.
When a jet aircraft turns, the lift must be increased to maintain altitude because the lift vector is tilted due to banking. This is done by increasing the angle of attack. However, increasing the angle of attack also increases drag, especially induced drag. To maintain airspeed, thrust must be increased to overcome this additional drag. Therefore, to maintain both airspeed and altitude during a turn, the correct con - Torsional aileron flutter involves?
- A) c of G aft of hinge line and cyclic twisting of wings.
- B) C of G aft of C of P and cyclic twisting of wings.
- C) C of P fwd of torsional axis and cyclic twisting of wings.
- D) None of the above.
Show answer
A) c of G aft of hinge line and cyclic twisting of wings.
Torsional aileron flutter occurs when the center of gravity of the aileron lies aft of its hinge line, which leads to unstable oscillations. As the aileron moves due to aerodynamic forces, it can induce a cyclic twisting motion in the wing structure. If this movement resonates with the natural torsional frequency of the wing, it can cause flutter, a dangerous and potentially destructive vibration. Proper mass balanci - Flexural aileron flutter involves?
- A) C of G aft of the hinge line and cyclic bending of wings.
- B) C of G aft of C of P and cyclic twisting of wings.
- C) C of p fwd of torsional axis and cyclic twisting of wings.
- D) None of the above.
Show answer
A) C of G aft of the hinge line and cyclic bending of wings.
Flexural aileron flutter involves a condition where the center of gravity of the aileron is located aft of its hinge line, causing instability. Unlike torsional flutter, which involves twisting, flexural flutter is characterized by cyclic bending of the wing structure in combination with aileron oscillations. This interaction between wing bending and control surface movement can lead to divergent vibrations, which ar - Swept back wings are …….. to divergence?
- A) More prone.
- B) Less prone.
- C) Never prone.
- D) None of the above.
Show answer
B) Less prone.
Swept back wings are less prone to divergence because the aerodynamic center is shifted rearward relative to the wing’s torsional axis. This rearward shift improves aeroelastic stability, meaning any twisting tends to reduce the angle of attack, creating a restoring moment. In contrast, straight wings or those with the center of pressure forward of the torsional axis are more prone to divergence—a condition where twi - Why might trim tabs be employed in power assisted flying controls?
- A) To enable control to be maintained following hydraulic failure.
- B) To reduce control forces to zero.
- C) To prevent overstressing of hydraulic actuators.
- D) To provide mach trim.
Show answer
B) To reduce control forces to zero.
In power-assisted flying controls, hydraulic actuators carry most of the control hinge moments, but the pilot still feels a portion of these forces. To avoid pilot fatigue from holding the controls against continuous hinge moments during trimming, trim tabs are used. These tabs create aerodynamic forces that hold the control surface in the desired trimmed position, thereby reducing the trim-induced control forces to