OXFORD ELECTRIC Electrical power systems

40 questions · tap an answer to check it

Learn this topic firstAircraft DC Power SystemsElectrics course →

About this topic

OXFORD ELECTRIC Electrical power systems: 40 multiple-choice questions for the DGCA CPL and ATPL examinations. Every question shows the correct answer and an explanation. You can practise free for a few minutes; a subscription opens every question bank, previous paper and airline preparation set.

Sample questions from OXFORD ELECTRIC Electrical power systems

  1. In an electrical circuit the reverse current cut-out relay will open:
    • A) when battery voltage exceeds generator voltage.
    • B) when circuit voltage is less than generator voltage.
    • C) when the main output C/B is reset.
    • D) when the batteries are flat.
    Show answer

    A) when battery voltage exceeds generator voltage.

  2. A generator cut-out is provided:
    • A) to prevent the battery over heating.
    • B) to prevent the battery from being overcharged.
    • C) to allow the generator to be isolated in a crash.
    • D) to prevent discharge of the battery through the generator.
    Show answer

    D) to prevent discharge of the battery through the generator.

  3. A generator cut-out will open when:
    • A) circuit loads equal the battery voltage.
    • B) the air temperature reaches 45 C.
    • C) circuit loads equal the generator voltage.
    • D) generator voltage falls below battery voltage.
    Show answer

    D) generator voltage falls below battery voltage.

  4. A generator cut-out is fitted to prevent:
    • A) the battery discharging through the generator windings.
    • B) the generator overcharging the battery.
    • C) fire in the event of overloading the system.
    • D) out of phasing.
    Show answer

    A) the battery discharging through the generator windings.

  5. In the event of the cut-out points sticking in the closed position, the most probable results, when the engine stopped would be:
    • A) gain of engine power.
    • B) a burnt out generator.
    • C) loss of residual magnetism.
    • D) no apparent reaction.
    Show answer

    B) a burnt out generator.