OXFORD ENGINES Bleed air

9 questions · tap an answer to check it

Learn this topic firstEngine Bleed AirEngines course →

About this topic

OXFORD ENGINES Bleed air: 9 multiple-choice questions for the DGCA CPL and ATPL examinations. Every question shows the correct answer and an explanation. You can practise free for a few minutes; a subscription opens every question bank, previous paper and airline preparation set.

Sample questions from OXFORD ENGINES Bleed air

  1. An inter-stage air seal is used where:
    • A) Engine sections are operating at different pressures.
    • B) Engine sections are subjected to pressures of the same value.
    • C) It is more convenient.
    • D) It is difficult to obtain access during routine servicing.
    Show answer

    A) Engine sections are operating at different pressures.

  2. An Internal Engine Overheat warning would necessitate:
    • A) The oil temperature to be closely monitored.
    • B) The EGT to be closely monitored.
    • C) The engine power to be reduced to idle.
    • D) The engine to be shut down.
    Show answer

    D) The engine to be shut down.

  3. Turbine blades are cooled by:
    • A) H.P. compressor air internally ducted through the blades.
    • B) H.P. air tapped from the combustion chambers.
    • C) Air ducted from just before the intake guide vanes.
    • D) Intermediate pressure air taken from the bleed valves.
    Show answer

    A) H.P. compressor air internally ducted through the blades.

  4. Bleed air for engine anti-icing is provided by:
    • A) The bleed valves
    • B) The turbine stages.
    • C) The compressor.
    • D) The combustion chambers.
    Show answer

    C) The compressor.

  5. The efficiency of a bearing chamber oil seal depends on its mechanical design and:
    • A) The fuel pressure.
    • B) Compressor bleed air pressure.
    • C) The engine compression ratio.
    • D) The engine oil pressure.
    Show answer

    B) Compressor bleed air pressure.