About this topic
OXFORD ENGINES Carburettors : 20 multiple-choice questions for the DGCA CPL and ATPL examinations. Every question shows the correct answer and an explanation. You can practise free for a few minutes; a subscription opens every question bank, previous paper and airline preparation set.
Sample questions from OXFORD ENGINES Carburettors
- The pressure in the induction manifold of a normally aspirated engine:
- A) Remains constant as the throttle is opened.
- B) Decreases as the throttle is opened.
- C) Initially increases as the throttle is opened but decreases after approximately the half open position.
- D) Increases as the throttle is opened.
Show answer
D) Increases as the throttle is opened.
- The purpose of an accelerator pump is to:
- A) Assist in the atomisation of the fuel before it leaves the discharge nozzle.
- B) Prevent a rich cut when the throttle lever is advanced rapidly.
- C) Prevent dissociation and detonation.
- D) Prevent a weak cut when the throttle lever is advanced rapidly.
Show answer
D) Prevent a weak cut when the throttle lever is advanced rapidly.
- The fuel flow to a piston engine will vary according to:
- A) The R.P.M. and the throttle position only.
- B) The R.P.M. the throttle position and the mixture setting.
- C) The R.P.M. and the mixture setting only.
- D) The R.P.M. only.
Show answer
B) The R.P.M. the throttle position and the mixture setting.
- The primary function of a diffuser in a carburettor is to:
- A) Control the mixture strength over part of the engine speed range.
- B) Vent air from the float chamber.
- C) Emulsify the fuel during engine acceleration.
- D) Enable adjustment of the engine slow running speed.
Show answer
A) Control the mixture strength over part of the engine speed range.
- The venturi in the carburettor choke tube creates:
- A) A positive pressure over the discharge nozzle.
- B) A depression over the fuel discharge nozzle.
- C) A positive pressure at the throttle valve.
- D) A decrease in the velocity of the air entering the engine.
Show answer
B) A depression over the fuel discharge nozzle.