OXFORD ENGINES Gas turbine lubrication

17 questions · tap an answer to check it

Learn this topic firstGas Turbine LubricationEngines course →

About this topic

OXFORD ENGINES Gas turbine lubrication: 17 multiple-choice questions for the DGCA CPL and ATPL examinations. Every question shows the correct answer and an explanation. You can practise free for a few minutes; a subscription opens every question bank, previous paper and airline preparation set.

Sample questions from OXFORD ENGINES Gas turbine lubrication

  1. A centrifugal breather is used on a gas turbine engine:
    • A) To circulate the oil smoothly.
    • B) To minimise oil loss.
    • C) To emulsify the oil and air mixture for greater viscosity.
    • D) To allow oxidisation of the oil.
    Show answer

    B) To minimise oil loss.

  2. A high oil temperature would indicate that:
    • A) The oil pressure was high.
    • B) The exhaust gas temperature (E.G.T.) was high.
    • C) The oil filter was blocked.
    • D) The air intake of the oil cooler was blocked.
    Show answer

    D) The air intake of the oil cooler was blocked.

  3. Oil seals are pressurised:
    • A) To ensure oil is forced into the bearings.
    • B) To ensure minimum oil loss.
    • C) To ensure that the oil is prevented from leaving the bearing housing.
    • D) To minimise heat loss in the bearing housing.
    Show answer

    B) To ensure minimum oil loss.

  4. In the event that damage occurs to the matrix of the fuel cooled oil cooler:
    • A) A pressure-maintaining valve ensures that the oil pressure is always higher than the fuel pressure.
    • B) The fuel pressure is always kept higher than the oil pressure to ensure that the fuel will leak into the oil system.
    • C) A differential pressure switch will illuminate a light in the cockpit.
    • D) The oil by-pass valve will prevent a complete loss of oil pressure.
    Show answer

    A) A pressure-maintaining valve ensures that the oil pressure is always higher than the fuel pressure.

  5. The bearing chambers of a gas turbine engine are vented:
    • A) Via the auxiliary gear box drive.
    • B) Via the centrifugal breather.
    • C) Via the air seals, into the gas stream.
    • D) To prevent oil loss.
    Show answer

    B) Via the centrifugal breather.