OXFORD ENGINES Performance and thrust augmentation

6 questions · tap an answer to check it

Learn this topic firstPerformance and Thrust AugmentationEngines course →

About this topic

OXFORD ENGINES Performance and thrust augmentation: 6 multiple-choice questions for the DGCA CPL and ATPL examinations. Every question shows the correct answer and an explanation. You can practise free for a few minutes; a subscription opens every question bank, previous paper and airline preparation set.

Sample questions from OXFORD ENGINES Performance and thrust augmentation

  1. When leaving the turbine the gas stream:
    • A) Increases velocity immediately to maximise thrust.
    • B) Is diffused to ensure the afterburning flame is stabilised.
    • C) Goes through a convergent duct to ensure the after-burning flame is stabilised.
    • D) Goes through a divergent duct to maximise thrust.
    Show answer

    B) Is diffused to ensure the afterburning flame is stabilised.

  2. Which of the following statements are correct with regard to after-burning? 1.Fuel consumption increases 2.Fuel consumption decreases .3 Pressure thrust decreases ,4 thrust increases, 5 pressure thrust increases, 6 EGT increases ,7 EGT decreases ,8 Thrust decreases.
    • A) 6,5,4,1
    • B) 1,3,4,6
    • C) 2,4,5,6
    • D) 8,1,5,7
    Show answer

    A) 6,5,4,1

  3. On a turbojet aircraft which of the following statements would be correct with the introduction of water into the combustion chamber?
    • A) Power can be restored up to its flat rated 100% only, and is prevented from exceeding its limitations due to a pressure sensor at the high pressure outlet.
    • B) Power can be restored up to its flat rated 100% only, due to a pressure sensor at the combustion chamber outlet.
    • C) Power can be restored up to its flat rated 100% only, due to a pressure sensor in the exhaust.
    • D) Power can be augmented above100% due to the denser mixture impinging on the turbine, which consequently drives the compressor quicker.
    Show answer

    A) Power can be restored up to its flat rated 100% only, and is prevented from exceeding its limitations due to a pressure sensor at the high pressure outlet.

  4. In a turboprop aircraft with water methanol injection in the combustion chamber, which of the following statements would be correct?
    • A) SHP can be re-established up to 100% only, when operating in warmer climates.
    • B) SHP can be increased beyond 100% by maintaining the RPM and increasing the blade angle.
    • C) SHP can be increased beyond 100% by increasing RPM and decreasing the blade angle.
    • D) SHP can be increased beyond 100% by maintaining RPM and decreasing the blade angle.
    Show answer

    B) SHP can be increased beyond 100% by maintaining the RPM and increasing the blade angle.

  5. Water Methanol is injected into an engine so that the combustion chamber inlet temperature is reduced and there is:
    • A) A substantial power decrease.
    • B) A substantial power increase with no increase in fuel flow.
    • C) A substantial power increase which is due solely to the combustion of methanol.
    • D) An increase in power output solely due to the increased fuel flow, since methanol does not burn.
    Show answer

    B) A substantial power increase with no increase in fuel flow.