OXFORD ENGINES Turbine assembly

10 questions · tap an answer to check it

Learn this topic firstThe Turbine AssemblyEngines course →

About this topic

OXFORD ENGINES Turbine assembly: 10 multiple-choice questions for the DGCA CPL and ATPL examinations. Every question shows the correct answer and an explanation. You can practise free for a few minutes; a subscription opens every question bank, previous paper and airline preparation set.

Sample questions from OXFORD ENGINES Turbine assembly

  1. The effect on the temperature and pressure of the gases as they pass across the turbine is:
    • A) Their temperature decreases and their pressure rises.
    • B) Both their temperature and pressure increase.
    • C) Both their temperature and pressure decrease.
    • D) Their temperature increases and their pressure falls.
    Show answer

    C) Both their temperature and pressure decrease.

  2. Nozzle guide vanes are fitted before the turbine:
    • A) To increase the velocity of the airflow.
    • B) To decrease the velocity of the gas flow therefore increasing its pressure.
    • C) To increase the velocity of the gas flow therefore reducing its pressure.
    • D) To increase the temperature of the gas flow.
    Show answer

    C) To increase the velocity of the gas flow therefore reducing its pressure.

  3. One reason for shrouding turbine blades is:
    • A) To reduce “creep” which may occur in the blades.
    • B) To improve efficiency and reduce vibration.
    • C) To enable thinner blades to be used.
    • D) To minimise blade end erosion.
    Show answer

    B) To improve efficiency and reduce vibration.

  4. The blades are usually attached to the turbine disc by a “Fir Tree” root. A tight fit is ensured during operation:
    • A) By the action of centrifugal force.
    • B) By thermal expansion of the disc.
    • C) By blade compression loads and thermal expansion.
    • D) By torque loading and thermal expansion.
    Show answer

    A) By the action of centrifugal force.

  5. The main contributory factors which cause creep in turbine blades are:
    • A) High temperature and tensile loading.
    • B) High rpm and torque loading.
    • C) High rpm and high gas speeds.
    • D) High temperature and high gas speeds.
    Show answer

    A) High temperature and tensile loading.