OXFORD POF AIRFRAME CONTAMINATION

7 questions · tap an answer to check it

Learn this topic firstAirframe ContaminationPrinciples of Flight course →

About this topic

OXFORD POF AIRFRAME CONTAMINATION: 7 multiple-choice questions for the DGCA CPL and ATPL examinations. Every question shows the correct answer and an explanation. You can practise free for a few minutes; a subscription opens every question bank, previous paper and airline preparation set.

Sample questions from OXFORD POF AIRFRAME CONTAMINATION

  1. After an aircraft has been exposed to severe weather:
    • A) snow should be removed but smooth ice may be left
    • B) all snow and ice should be removed
    • C) loose snow may be left but ice must be removed
    • D) providing the contamination is not too thick, it may be left in place
    Show answer

    B) all snow and ice should be removed
    After an aircraft has been exposed to severe weather, all snow and ice should be removed before flight. Even a thin layer of ice or frost can disrupt airflow over the wings and control surfaces, decreasing lift and increasing drag, potentially compromising flight safety.

  2. Icing conditions may be encountered in the atmosphere when:
    • A) relative humidity is low and temperature rises
    • B) pressure is high and humidity falls
    • C) relative humidity is high and temperature is low
    • D) relative pressure is high and temperature is high
    Show answer

    C) relative humidity is high and temperature is low
    Icing conditions are most likely when moist air (high relative humidity) is present and the temperature is low, typically near or below 0°C. Under these conditions, supercooled water droplets can freeze upon contact with an aircraft’s surfaces, leading to airframe or engine icing.

  3. Which is an effect of ice, snow, or frost formation on an aeroplane?
    • A) Increased angle of attack for stalls
    • B) Increased stall speed
    • C) Increased pitch down tendencies
    • D) Decreased speed for stalling
    Show answer

    B) Increased stall speed
    Ice, snow, or frost formation disrupts the smooth airflow over the wing, reducing lift and increasing drag. This causes the aircraft to stall at a higher airspeed than normal, leading to an increased stall speed. Even a thin layer of contamination can significantly degrade aerodynamic performance.

  4. Frost covering the upper surface of an aircraft wing will usually cause:
    • A) the aircraft to stall at an angle of attack that is lower than normal
    • B) no problems to pilots
    • C) drag factors so large that sufficient speed cannot be obtained for take-off
    • D) the aircraft to stall at an angle of attack that is higher than normal
    Show answer

    A) the aircraft to stall at an angle of attack that is lower than normal
    Frost on the upper surface of the wing disrupts the laminar airflow, causing early airflow separation. This reduces lift and means the wing can stall at a lower angle of attack than normal, potentially leading to a dangerously early stall during takeoff or flight.

  5. If it is suspected that ice may have formed on the tailplane and longitudinal control difficulties are experienced following flap selection. the prudent action to take would be:
    • A) immediately decrease the flap setting
    • B) allow the speed to increase
    • C) select a greater flap deflection because this will increase C L max
    • D) reduce the angle of attack
    Show answer

    A) immediately decrease the flap setting
    If ice forms on the tailplane, it can disrupt airflow and cause tailplane stall, especially after flap deployment, which shifts the aerodynamic load rearward. This can lead to longitudinal control difficulties (e.g., nose pitching down). The safest immediate action is to reduce flap setting to relieve the aerodynamic load on the iced tailplane and regain control authority.