OXFORD POF CONTROLS 

44 questions · tap an answer to check it

Learn this topic firstRoll, Yaw and TrimPrinciples of Flight course →

About this topic

OXFORD POF CONTROLS : 44 multiple-choice questions for the DGCA CPL and ATPL examinations. Every question shows the correct answer and an explanation. You can practise free for a few minutes; a subscription opens every question bank, previous paper and airline preparation set.

Sample questions from OXFORD POF CONTROLS 

  1. When rolling at a steady rate the:
    • A) up going wing experiences an increase in effective angle of attack
    • B) rate of roll depends only on aileron deflection
    • C) down going wing experiences an increase in effective angle of attack
    • D) effective angle of attack of the up going and down wings are equal
    Show answer

    C) down going wing experiences an increase in effective angle of attack
    When an aircraft is rolling at a steady rate, the down-going wing moves downward relative to the airflow, which causes it to present a greater angle to the oncoming air. This results in an increased effective angle of attack on the down-going wing. This happens because of the combination of forward true airspeed (TAS) and the angular motion at the wingtip due to the roll. The downward vector of motion adds to the rel

  2. The control surface which gives longitudinal control is:
    • A) the rudder
    • B) the ailerons
    • C) the elevators
    • D) the flaps
    Show answer

    C) the elevators
    The elevators are the primary control surfaces that provide longitudinal control of an aircraft, which means control about the lateral axis (pitching motion). They are usually located on the horizontal stabilizer at the tail of the aircraft. By moving the elevators up or down, the pilot changes the angle of attack of the horizontal tail, which in turn causes the nose of the aircraft to pitch up or down, thereby contr

  3. Aileron reversal would be most likely to occur:
    • A) with a rigid wing at high speed
    • B) with a flexible wing at high speed
    • C) with a rigid wing at low
    • D) with a flexible wing at low speed
    Show answer

    B) with a flexible wing at high speed
    Aileron reversal occurs when the down-going aileron twists a flexible wing at high speeds, causing the wing tip incidence to decrease so much that the wing produces a downforce instead of an upforce. This effect is more pronounced in flexible wings and at high speeds where aerodynamic forces are stronger.

  4. If the ailerons are deflected to 10 DEG, compared to 5 DEG this will cause:
    • A) an increased angle of bank
    • B) an increased rate of roll
    • C) no change to either bank angle or roll rate
    • D) a reduction in the adverse yawing moment
    Show answer

    B) an increased rate of roll
    Increasing the aileron deflection from 5° to 10° increases the difference in lift between the wings, which results in a greater rolling moment and therefore a higher rate of roll.

  5. Yawing is a rotation around:
    • A) the normal axis obtained by elevator
    • B) the lateral axis obtained by rudder
    • C) the longitudinal axis obtained by ailerons
    • D) the normal axis obtained by rudder
    Show answer

    D) the normal axis obtained by rudder
    Yawing is a rotation about the normal axis (vertical axis), controlled by the rudder which moves the aircraft’s nose left or right.