OXFORD SYSTEMS Aircraft brakes

23 questions · tap an answer to check it

Learn this topic firstBrakes, Anti-skid and AutobrakeAircraft Systems course →

About this topic

OXFORD SYSTEMS Aircraft brakes: 23 multiple-choice questions for the DGCA CPL and ATPL examinations. Every question shows the correct answer and an explanation. You can practise free for a few minutes; a subscription opens every question bank, previous paper and airline preparation set.

Sample questions from OXFORD SYSTEMS Aircraft brakes

  1. Oil is used in an oleo strut to:
    • A) support the weight of the aircraft
    • B) limit the speed of compression of the strut
    • C) lubricate the piston within the cylinder.
    • D) limit the speed of extension and compression of the strut
    Show answer

    D) limit the speed of extension and compression of the strut
    In an oleo strut, oil (hydraulic fluid) is used to provide damping by controlling the rate of compression and extension. As the strut compresses or extends, the oil is forced through small orifices, which resists sudden movements, preventing harsh shocks during landing and smoothing out rebound, ensuring safe and stable performance.

  2. The nose wheel assembly must be centered before retraction because:
    • A) there is limited space in the nose wheel bay
    • B) the aircraft may swerve on the next landing if the nose wheel is not straight.
    • C) the tyres may be damaged on landing if the nose wheel is not straight.
    • D) it will remove any slush or debris which may have accumulated on take-off.
    Show answer

    A) there is limited space in the nose wheel bay
    The nose wheel must be centered before retraction because the nose wheel bay has limited space, designed to accommodate the gear only in a specific alignment. If not properly centered, the gear may jam during retraction, cause mechanical damage, or fail to lock properly, posing a safety risk for future deployment.

  3. The movement of the gear on lowering is normally damped to:
    • A) prevent the fluid becoming aerated.
    • B) counteract the force of gravity which would bring the gear down too fast.
    • C) make the lowering time greater than the raising time.
    • D) prevent the hydraulic fluid becoming overheated.
    Show answer

    B) counteract the force of gravity which would bring the gear down too fast.
    When the landing gear is lowered, gravity assists the movement. Without damping, it could fall too quickly, causing mechanical stress or damage. Damping slows the motion in a controlled manner, ensuring the gear extends smoothly and safely, and properly locks into position without shock loading the structure.

  4. Inadvertent retraction of the landing gear on the ground is:
    • A) not possible because the system is not powerful enough.
    • B) prevented by the ground/air logic system.
    • C) always a danger after the ground locks have been removed.
    • D) the responsibility of the first officer when he is on the aircraft.
    Show answer

    B) prevented by the ground/air logic system.
    Inadvertent retraction of the landing gear on the ground is prevented by a ground/air logic system, which uses inputs like weight-on-wheels (WOW) switches. These sensors detect whether the aircraft is on the ground and inhibit gear retraction while grounded, ensuring safety during taxiing and maintenance operations.

  5. Tyre wear when taxying can be reduced:
    • A) restricting the use of brakes and using thrust reversers.
    • B) taxying at less than 40 kph.
    • C) staying on the smoothest parts of the taxiway.
    • D) taxying at less than 25 knots.
    Show answer

    B) taxying at less than 40 kph.
    To reduce tyre wear during taxiing, it is recommended to limit speed to 25 mph (40 kph). Higher taxi speeds increase heat buildup, friction, and tyre degradation. With longer taxi distances at large airports, maintaining this speed helps extend tyre life and reduces the risk of damage from surface irregularities and excessive braking.