OXFORD SYSTEMS Basic hydraulics

50 questions · tap an answer to check it

Learn this topic firstHydraulic Principles and FluidsAircraft Systems course →

About this topic

OXFORD SYSTEMS Basic hydraulics: 50 multiple-choice questions for the DGCA CPL and ATPL examinations. Every question shows the correct answer and an explanation. You can practise free for a few minutes; a subscription opens every question bank, previous paper and airline preparation set.

Sample questions from OXFORD SYSTEMS Basic hydraulics

  1. A force of 100N is applied to 2 separate jacks, the area of one is 0.02m2 and the other is 0.04m2:
    • A) the smaller jack will exert a pressure of 2,000Pa and the larger 4,000 Pa.
    • B) the smaller jack will exert a pressure of 5,000 Pa and the larger 2,500 Pa.
    • C) both jacks will move at the same speed.
    • D) both have the same load.
    Show answer

    B) the smaller jack will exert a pressure of 5,000 Pa and the larger 2,500 Pa.
    Pressure = Force / Area For the smaller jack (Area = 0.02 m²):Pressure = 100 / 0.02 = 5,000 Pa For the larger jack (Area = 0.04 m²):Pressure = 100 / 0.04 = 2,500 Pa

  2. A pre charge pressure of 1,000 bar of gas is shown on the accumulator gauge. The system is then pressurised to 1,500 bar, so the accumulator will read:
    • A) 500 bar.
    • B) 1,000 bar.
    • C) 1,500 bar.
    • D) 2,500 bar.
    Show answer

    C) 1,500 bar.
    When an accumulator is pre-charged with gas to 1,000 bar, and the hydraulic system is then pressurised to 1,500 bar, the accumulator gauge (which measures system pressure) will read the system pressure, not the gas pressure. So, once the system is pressurised to 1,500 bar, the accumulator gauge will also show: 1,500 bar

  3. The pressure gauge of an hydraulic system provides information regarding the pressure of:
    • A) the air in the accumulator.
    • B) the air and hydraulic fluid in the system.
    • C) the proportional pressure in the system.
    • D) the hydraulic fluid in the system.
    Show answer

    D) the hydraulic fluid in the system.
    The pressure gauge in a hydraulic system provides information about the pressure of the hydraulic fluid within the system. It is used to monitor system performance and ensure proper operation of hydraulic components. It does not measure air pressure in the accumulator or a mix of air and fluid.

  4. Def. Stan 91/48 is ———- and is ————- based:
    • A) red , mineral
    • B) red , synthetic
    • C) green, mineral
    • D) purple, synthetic
    Show answer

    A) red , mineral
    Def. Stan 91/48 is a red, mineral-based hydraulic fluid used in aviation systems. It is typically used in non-flammable hydraulic systems and is compatible with components designed for mineral oils.

  5. With a hyd lock there is:
    • A) flow, but no jack movement.
    • B) no flow but jack continues to move under gravitational effects.
    • C) no flow, jack is stationary.
    • D) constant flow.
    Show answer

    C) no flow, jack is stationary.
    With a hydraulic lock (hyd lock), fluid is trapped on both sides of a jack or actuator, preventing any further movement. This condition results in no flow and the jack remains stationary, even under external forces like gravity.