About this topic
OXFORD SYSTEMS Ice and rain protection: 20 multiple-choice questions for the DGCA CPL and ATPL examinations. Every question shows the correct answer and an explanation. You can practise free for a few minutes; a subscription opens every question bank, previous paper and airline preparation set.
Sample questions from OXFORD SYSTEMS Ice and rain protection
- The electrical supply to the propeller blades for de-icing purposes:
- A) is controlled to give an intermittent supply.
- B) must be taken directly from the APU generator.
- C) must only be selected on for short periods.
- D) is continuous to all blades.
Show answer
A) is controlled to give an intermittent supply.
The electrical supply to propeller blades for de-icing is controlled to give an intermittent supply, heating each blade in sequence to prevent overload and ensure effective ice removal. - Propeller blade heating elements are:
- A) fitted only to the thin outer sections where maximum ice accretion occurs.
- B) fitted only to the thick inner section where minimum ice accretion occurs.
- C) usually fitted to the thick section but sometimes a second element is fitted to a mid section.
- D) fitted to the complete leading edge.
Show answer
C) usually fitted to the thick section but sometimes a second element is fitted to a mid section.
Propeller blade heating elements are usually fitted to the thick inner section of the blade, as this area is most prone to initial ice formation. In some designs, a second heating element is also fitted to the mid section to enhance ice removal efficiency. - When an aircraft is de-iced prior to departure, if the temperature is 0 C in precipitation, which type of fluid and application method will provide the longest holdover period:
- A) Type I fluid at 100% cold spray application.
- B) Type II fluid diluted to 50% hot spray application.
- C) Type I fluid diluted to 50% hot spray application.
- D) Type II fluid at 100% cold spray application.
Show answer
D) Type II fluid at 100% cold spray application.
At 0°C in precipitation, Type II fluid at 100% cold spray application provides the longest holdover period, as its thicker consistency resists being washed off and delays ice formation longer than Type I fluids. - The effect of frost on an aircraft:
- A) is to cause an increase in boundary layer energy and so delay the onset of the stall.
- B) can be generally ignored.
- C) has no significant effect on the aerodynamic contour or CL max.
- D) is to cause an increase in the surface roughness which in turn increases skin friction and reduces the kinetic energy of the boundary layer.
Show answer
D) is to cause an increase in the surface roughness which in turn increases skin friction and reduces the kinetic energy of the boundary layer.
The effect of frost on an aircraft is to increase surface roughness, which increases skin friction and reduces the kinetic energy of the boundary layer. This degrades aerodynamic performance, increases stall speed, and reduces lift efficiency, making frost removal essential before flight to ensure safe operations. - In flight airframe icing does not occur:
- A) above 25,000 ft.
- B) above 40,000 ft.
- C) above 35,000 ft.
- D) above 30,000 ft.
Show answer
B) above 40,000 ft.
In-flight airframe icing requires visible moisture and freezing temperatures (0°C to about -40°C). At altitudes above 40,000 ft, temperatures are generally too low for supercooled liquid water to exist, so ice formation on the airframe does not occur.