PANS ATM

98 questions · tap an answer to check it

Learn this topic firstApproach and Circling ProceduresAir Law course →

About this topic

PANS ATM: 98 multiple-choice questions for the DGCA CPL and ATPL examinations. Every question shows the correct answer and an explanation. You can practise free for a few minutes; a subscription opens every question bank, previous paper and airline preparation set.

Sample questions from PANS ATM

  1. The document that specifies the recommendations for instrument procedures is called...
    • A) PANS OPS Doc 8168
    • B) The Convention of Chicago
    • C) The Air Navigation bulletin
    Show answer

    A) PANS OPS Doc 8168
    The Procedures for Air Navigation Services (PANS-OPS) is detailed in Doc 8168. It consists of two volumes. Volume I describes recommended operational procedures for flight operations personnel and crew. Volume II ensures uniform practices at all aerodromes conducting instrument flight procedures.

  2. Which of the following defines transition altitude?
    • A) The altitude above which the vertical position of an aircraft is determined by reference to local QHN
    • B) The altitude above which the vertical position of an aircraft is determined by reference to local QHN
    • C) The altitude at which 1013 hPa is set and vertical position then reported as a flight level
    Show answer

    C) The altitude at which 1013 hPa is set and vertical position then reported as a flight level
    The altitude above the aerodrome for change from QNH to Standard Pressure Setting (1013 hPa) is called the transition altitude. Transition Level. The transition level is the flight level at which the altimeter is reset to the aerodrome QNH and subsequent flight is reported with reference to altitude.

  3. During flight through the transition layer the vertical position of the aircraft should be expressed as
    • A) Altitude above mean sea level during climb.
    • B) Either altitude above mean sea level or flight level during climb
    • C) Altitude above mean sea level during descent
    Show answer

    C) Altitude above mean sea level during descent
    Transition Layer is the airspace between the Transition Altitude (TA) (altitude referenced to QNH) and the Transition Level (TL) (flight level referenced to standard pressure setting SPS or 1013.25 hPa). Ascending through the Transition Layer: Vertical position is reported in flight levels (FL) using SPS (Standard Pressure Setting). Descending through the Transition Layer: Vertical position is reported in altitude us

  4. Transition from altitude to flight level, and vice-versa is done:
    • A) At transition level during climb and transition altitude during descent
    • B) At transition altitude during climb and transition level during descent
    • C) Only at transition altitude
    Show answer

    B) At transition altitude during climb and transition level during descent
    The transition altitude is the altitude above which aircraft switch from using altitude (measured in feet) to flight levels (measured in hundreds of feet) based on standard pressure settings (SPS). Below the transition altitude, pilots set their altimeters to the local QNH, which provides the actual altitude above sea level. Once above the transition altitude, they set their altimeters to the standard pressure settin

  5. Which of the following cruising levels would you select under the following conditions: True track 358°, variation 3°E, deviation 2°W?
    • A) FL 65
    • B) FL 75
    • C) FL 70
    Show answer

    A) FL 65
    °