TURNING FLIGHT

73 questions · tap an answer to check it

Learn this topic firstTurning Flight and Load FactorPrinciples of Flight course →

About this topic

TURNING FLIGHT: 73 multiple-choice questions for the DGCA CPL and ATPL examinations. Every question shows the correct answer and an explanation. You can practise free for a few minutes; a subscription opens every question bank, previous paper and airline preparation set.

Sample questions from TURNING FLIGHT

  1. What control inputs are required to maintain airspeed and altitude when turning in a jet aircraft?
    • A) Increase thrust and angle of attack.
    • B) Increase turn radius and decrease thrust.
    • C) Increase pitching angle.
    • D) Increase bank angle.
    Show answer

    A) Increase thrust and angle of attack.
    When a jet aircraft turns, lift is divided between the vertical (to support weight) and horizontal (to turn the aircraft) components. To maintain altitude, the aircraft must increase total lift, which is achieved by: Increasing the angle of attack (pitch up slightly) Adding thrust to maintain airspeed, since the increased lift creates more induced drag If these adjustments are not made, the aircraft will lose altitud

  2. What turn radius will be achieved in a balanced turn at a true airspeed of 250 Kts if the aircraft is banked to 45 degrees? Use g = 10 m/s2, 1 Kt = 0.51 m/s
    • A) 1625.25 m.
    • B) 1725.25 m.
    • C) 6250 m.
    • D) 2675 m.
    Show answer

    A) 1625.25 m.

  3. By what % will the load factor increase if an aircraft enters a balanced 60° banked turn?
    • A) 41%
    • B) 50%
    • C) 100%
    • D) 141%
    Show answer

    C) 100%
    In a balanced turn, the load factor (n) increases with bank angle and is given by:Load Factor = 1 / cos(Bank Angle) For a 60° banked turn: cos(60°) = 0.5,so, Load Factor = 1 / 0.5 = 2 This means the aircraft experiences a load that is twice its weight, i.e., a 100% increase in load factor compared to level flight (which has a load factor of 1).

  4. Two aircraft, one of high mass and the other of low mass enter a 30° balanced banked turn at a TAS of 300 Kts. Which of the following statements best describes the results?
    • A) Low mass aircraft will achieve the tightest (lowest radius) turn.
    • B) High mass aircraft requires less power than low mass aircraft for same turn radius.
    • C) The high mass aircraft will achieve the highest rate of turn.
    • D) Both aircraft will achieve the same turn radius and rate of turn.
    Show answer

    D) Both aircraft will achieve the same turn radius and rate of turn.
    In a balanced turn, the turn radius and rate of turn depend only on true airspeed and bank angle, not on aircraft mass. The formulas used are: Turn Radius = (TAS)² / (g × tan Bank Angle) Rate of Turn = (g × tan Bank Angle) / TAS Since both aircraft are flying at the same TAS (300 Kts) and with the same bank angle (30°), their turn radius and rate of turn will be identical, regardless of their mass.

  5. If radius of turn in a constant altitude banked turn at 250 Kts is 1000 m, what will it be at 500 Kts if all other factors remain unchanged?
    • A) 2000 m
    • B) 3000 m
    • C) 4000 m
    • D) 5000 m
    Show answer

    C) 4000 m
    In a constant altitude banked turn, the radius of turn is calculated using the formula:Turn Radius = (True Airspeed × True Airspeed) / (g × tan Bank Angle) Since bank angle and g remain constant, the turn radius is proportional to the square of the true airspeed.So, if the airspeed increases from 250 Kts to 500 Kts, that’s double the speed. Now:New Radius = (500 × 500) / (250 × 250) × 1000 = (4) × 1000 = 4000 m